Philips 107B4074 - Manual (Page 29)

original values stored in the monitor. By readjusting gain values of the individual cannons, deviation is
reduced to zero. Default values are stored during production. If the user sets a new color temperature, this
new value is saved as the new default value.
33. When should calibration be performed?
The calibration process takes less than six seconds. During this period, different specific images are
displayed. After the process is finalized, the original image is redisplayed. Constant re-calibration is not
required. Calibration should be performed after the monitor is warmed up. Auto Calibration takes place
when a monitor receives a signal indicating an imminent switch to its sleep mode/stand-by mode.
34. Which models of Philips monitors are equipped with Auto Calibrate feature?
Auto Calibrate is currently available in the new 201P, 201B and 109P.
35. The Main Menu displays OSD MAIN MENU LOCKED . Pressing the front control panels
hasno effect. How can I unlock this function?
Press and hold the OSD menu key for about 10 seconds until picture displays "OSD MAIN MENU
UNLOCKED"
36. My screen shows NO SYNC INPUT , how can I get rid of this?
Check the following for possible solutions:
Bent pins on the video cable ●
Make sure the computer is turned on ●
Ensure the VGA Cable is properly connected ●
Ensure the BNC/D-Sub connector on the rear of the monitor is in the correct position, newer
models have this option in the On Screen Display under Input Signal Selection. ●
Video card may be not be a VESA standard (try the monitor with another computer) ●
Frequently Asked Questions
file:///D|/Rita/LF3/lf3manual/english/FAQ.HTM (8 of 12) [2002/7/7 ?? 11:01:56]