Philips MCD708-37 - Manual (Page 34)

34
English
Radio Reception
Tuning to radio stations
1
Press ECO POWER/STANDBY-ON B (B
on the remote) to switch on the last selected
source.
2
Press SOURCE (TUNER on the remote) to
select TUNER mode.
3
Press TUNER on the remote again to select
the desired band: FM or AM.
4
Press and hold ¡ / ™ (CH +/- ¡ / ™ on the
remote) until the frequency indication starts to
change, then release.
➜
The system automatically tunes to the next
strong radio station.
● To tune to a weak station, press ¡ / ™ (CH +/-
а / б on the remote) briefly and repeatedly
until an optimal reception is found.
5
Repeat Step 4 if necessary until you find the
desired radio station.
Presetting radio stations
You can preset up to 40 stations (20 in each
band) regardless of the reception.
Automatic progamming
● Press PROG on the remote for more than two
seconds to activate programming.
➜ All available stations are programmed.
Manual progamming
1
Tune to your desired radio station (refer to
“Tuning to radio stations”).
2
Press PROG on the remote.
➜ ”PROG” icon flashes.
3
Press PRESET+ or PRESET-/
9 (or CH +/-
(
¡ / ™) on the remote) to select the desired
preset number.
➜
If “
PROG” icon goes off before you select the
desired preset number, press PROG on the
remote.
4
Press PROG on the remote again to store the
radio station.
●
Repeat steps 1-4 to store other radio stations.
Other Functions
Listening to preset radio stations
●
In tuner mode, press PRESET+ or PRESET-/
9
(or CH +/- (
¡ / ™) on the remote) to select
the desired preset number.
➜
The preset number, radio frequency, and
waveband are displayed.
Setting the clock
1
In Standby mode, press and hold CLOCKon
the remote until the time flashes on the display.
➜ ” CLOCK SET” is displayed briefly. Then, the
hour digits flash on the display screen.
2
Turn VOLUME -/+ clockwise or anticlockwise
or press VOLUME +/- on the remote to set
the hours.
3
Press CLOCK to confirm.
➜ The minute digits flash on the display screen.
4
Turn VOLUME -/+ clockwise or anticlockwise
or press VOLUME +/- on the remote to set
the minutes.
5
Press CLOCK again to confirm the clock
setting.
Notes:
– This system only supports 24-hour mode.
– The clock setting will be erased when the
system is disconnected from the power supply.
– The system will exit clock setting mode if no
button is pressed within 30 seconds.
Setting sleep/wake-up timer
Sleep timer setting
In power-on mode, the sleep setting enables
the system to switch to standby mode
automatically at a preset time.
1
In power-on mode, press SLEEP/TIMER on
the remote repeatedly to select a preset time.
➜
The selections are as follows (time in
minutes):
00
➜ 10 ➜ 20 ➜ 30 ➜ 40 ➜ 50 ➜ 60 ➜ 70
➜ 80 ➜ 90 ➜ 00
pg 001-041_MCD708_37 2006.3.1, 16:17 34