Philips VRA633AT99 - Manual (Page 40)

VCR PLUS+ PROG.
PLUS CODE : – – – – – – – –
TO END PUSH EXIT
40 Timer Recording with the VCR Plus+ Programming System
Follow these steps to set a timer recording with the PlusCode
programming numbers in your TV guide. Before you begin:
● Set up the channels at the VCR (page 12).
● Set up the VCR Plus+ and Cable/TV channel numbers (pages
38-39).
● Set the clock (pages 15-18).
● Put a tape in the VCR.
● Make sure the VCR light appears on the display panel. If it does
not, press the VCR/TV button once.
Do each step within 60 seconds of the previous step.
2
Press the VCR PLUS+/ENTER button.
3
Press the Number buttons to enter the PlusCode pro-
gramming number of the program you wish to record.
Then, press the VCR PLUS+/ENTER button.
VCR PLUS+ PROG.
PLUS CODE : 13285 – – –
TO SET PUSH VCR+
TO CORRECT PUSH CLEAR
TO END PUSH EXIT
4
Press the PLAY/o button or the STOP/p button to select
a ONCE, DAILY, or WEEKLY recording. Then, press the
F.FWD/B button.
● ONCE: The VCR will record a TV program on any day you
choose, up to 12 months away.
● DAILY: The VCR will record a program every day from
Monday to Friday – starting at the same time and recording for
the same length of time.
● WEEKLY: The VCR will record a program on the same day, at
the same time, and for the same length of time every week.
• If ERROR flashes on the screen when
you select a DAILY recording at step 4,
the program you selected takes place
on a weekend. Select ONCE or
WEEKLY for this program.
• CODE ERROR may flash on the screen
after step 3 if you enter an incorrect
PlusCode programming number (for
example, one that is too short). The
previous screen will appear. Enter the
correct PlusCode programming num-
ber.
• If CLASH flashes on the screen after
step 3, the timer recording you just
programmed and another timer
recording overlap. The previous screen
will appear. Enter a different PlusCode
programming number or cancel the
overlapping timer recording.
• If the VCR PLUS+ CROSS REF. MAP
reappears after step 3, the VCR PLUS
+ channel number for the recording
you entered was higher than 99. In this
case, enter the correct CABLE/TV chan-
nel in the map. Then, press the MENU
button and continue from step 4.
Helpful Hints
VCR PLUS+ PROG.
→ ONCE
DAILY
WEEKLY
SELECT op CHOOSE B
TO END PUSH EXIT
3
2
4
1
Press the VCR button.
1
VOL
CH
3 2 1
6 5 4
9 8 7
0
POWER
STATUS/EXIT
MEMORY SLOW REC/OTR
SPEED TIME SEARCH
VCR PLUS+/ENTER ALT. CH
PAUSE/STILL
MUTE
TV CBL/DBS VCR
F.FWD REW
PLAY
STOP
VCR/TV EJECT
MENU CLEAR