Philips 27" HDTV monitor TV - Manual (Page 6)

B
ASIC
A
NTENNA AND
C
ABLE
C
ONNECTIONS
Y our home’s signal input might come
from a single (75 ohm) round cable,
a Converter Box, or from an antenna.
In either case the connection to the TV
is very easy.
1 If your Cable TV signal or
Antenna signal is a round cable
(75 ohm) then you're ready to
connect to the TV.
If your antenna has flat twin-
lead wire (300 ohm), you first
need to attach the antenna wires
to the screws on a 300 to 75 ohm
adapter.
If you have a Cable Converter
Box: Connect the Cable TV sig-
nal to the Cable Signal IN(put)
plug on the Converter.
2 Connect the Cable TV cable or
Antenna cable (or 300 to 75 ohm
adapter) to the 75 ohm plug on the
TV.
If you have a Cable Converter
Box: Connect the OUT(put) plug
from the Converter to the 75 ohm
plug on the TV.
75
⍀
1
Back of TV
Cable signal
coming from
Cable Company
Jack Panel
Back of TV
75 ⍀
1
2
Antenna Connection
300 to 75 ohm
Adapter
Combination
VHF/UHF Antenna
(Outdoor or Indoor)
Twin Lead
Wire
Round Cable
75 ohm
Back of TV
Direct Cable Connection
75 ohm Round
Coaxial Cable
4
Y our Cable TV input into your
home may be a single (75 ohm)
cable or use a cable box decoder. In
either case the connection is very
simple. Follow the steps below to
connect your cable signal to your
new television.
This connection will supply Stereo
sound to the TV.
1 Connect the open end of the
round Cable Company supplied
cable to the 75 ohm input on the
TV. Screw it down finger tight.
After using the AutoProgram Control,
press the CH + and – buttons to scroll
through all the channels stored in the
television’s memory.
H
ELPFUL
H
INT