Bosch 24SBI - Manual (Page 3)

2
TO SET PRESENT TIME AND DAY
Set right switch to RUN.
Press HR & MIN buttons together (until colon stops flashing)
After 15 seconds the colon will start flashing again signifying the settings cannot be changed. Repeat this step if you still want
to set time and day.
Press DAY button until arrow points to correct day.
Press HR and MIN buttons separately until correct time is displayed.
Set right switch to DHW then back to RUN (or leave for 15 seconds) to start the clock.
TO SET PROGRAMME TIMES
This programmer provides eight switch periods per channel, with a day selection of Mon...Fri, Mon...Sat,
Sat/sun, all days together or all days individually. If it is considered confusing to programme all variations, the
following describes two levels of setting the programme; simple or full-function;
SIMPLE PROGRAMME SETTING
The programmer has an in-built programme of ‘standard’ switching times shown in the table. These may be
changed to suit your specific requirements.
PROGRAMMER OPERATING INSTRUCTIONS
M T W Th F S Su
P DAY HR MIN ADV
Reset
I AUTO O RUN DHW CH
Set
8 : 3 7
Normal run mode
Set DHW programme
Set CH programme
Channel 1 (DHW)
Channel 2 (CH)
Demand symbol (light bulb)
Advanced symbol
Programmer step number
Advance button
Set time or
programme minutes
Set time or
programme hours
Set actual or
programme day
Step through programme
Actual time or set time
Monday to Sunday
Permanent on
Timed programme
Permanent off
1 2
3
Fig. 2.
PROGRAMME STEP STANDARD PROGRAMME
DHW MON-FRI CH MON-FRI
1 6.30am 6.30am
2 8.30am 8.30am
3 4.30pm 4.30pm
4 10.30pm 10.30pm
SAT-SUN SAT-SUN
5 7.00am 7.00am
6 9.00am 9.00am
7 4.00pm 4.00pm
8 11.00pm 11.00pm