Bissell 8910 - Manual (Page 6)

This User’s Guide has been designed to help you
get the utmost satisfaction from your BISSELL
ProHeat. You’ll find assembly and operating
instructions, safety precautions, as well as
maintenance and troubleshooting instructions.
Please read this guide thoroughly before
assembling your deep cleaner.
Pay particular attention to the product diagram,
assembly instructions, and part names. Locate
and organize all parts before assembly. Familiarize
yourself with the parts and where they go.
Following this user’s guide will greatly enhance
your ability to get the most performance from
your BISSELL ProHeat for many years.
Your ProHeat comes in three, easy to
assemble components:
Upper Handle
Lower Handle
Tool Caddy
The only thing you will need to assemble your
cleaner is a Phillips head screwdriver.
Refer to Assembly Diagram on page 5
1.
Slide upper handle onto lower handle.
2. Feed bundled power cord through tool caddy from
caddy’s flat side.
3. Align upper handle holes and tool caddy holes.
4. Place hex nut into back of tool caddy and hold in
place. Insert bolt from front to back turning into
the hex nut until snug. Do not over tighten. Repeat
for the second bolt and hex nut.
5. Insert 2 screws into lower 2 holes. Turn until snug.
6. Snap tools into storage on the tool caddy.
7. Wrap power cord and flex hose as shown in figure 7.
ProHeat assembly is now complete.
Your BISSELL ProHeat deep cleaner is a home
cleaning system that automatically mixes hot
tap water with BISSELL advanced cleaning
formulas and heats the solution as it is applied
to the carpet. The combination of heated solution,
rotating brushes and powerful suction provide a
safe and effective method of cleaning.
H
ow to use this guide
6
w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
WARNING:
Do Not plug in your
cleaner until you have
completely assembled it per
the following instructions
and are familiar with all
instructions and operating
procedures.
1
6
A
ssembly
S
pecial features of your BISSELL ProHeat
1. 2.
3. 4.
5. 6.
7.
ug120-4080_7350_908.indd 6 10/14/08 1:26:54 PM