Digital tuner general information – Philips AZ157017 User Manual
Page 11

DIGITAL TUNER
GENERAL INFORMATION
11
To improve radio reception:
• For FM, pull out the telescopic antenna.
Incline and turn the antenna. Reduce its length if the signal is
too strong (very close to a transmitter).
• For AM, the set is provided with a built-in antenna so the
telescopic antenna is not needed. Direct the antenna by
turning the whole set.
Programming tuner stations
You can store up to a total of 30 tuner stations in the memory.
1. Tune to your desired station (see Tuning to radio stations).
2. Press PROG to activate programming.
™ Display:
PROG
flashes.
3. Press PRESET
3 or 4 once or more to allocate a number from
1 to 30 to this station.
4. Press PROG again to confirm the setting.
™ Display:
PROG
disappears, the preset number and the frequency
of the preset station are shown.
5. Repeat the above four steps to store other stations.
• You can overwrite a preset station by storing another
frequency in its place.
Tuning to preset stations
Press TUNER PRESET
4 or 3 until the desired preset station is
displayed.
General maintenance
• Do not expose the set, batteries, CDs or cassettes to humidity,
rain, sand or excessive heat caused by heating equipment or
direct sunlight.
• To clean the set, use a soft, slightly dampened chamois
leather. Do not use any cleaning agents containing alcohol,
ammonia, benzene or abrasives as these may harm the
housing.
Safety information
• Place the set on a hard and flat surface so that the system
does not tilt. Make sure there is adequate ventilation to
prevent the system from overheating.
• The mechanical parts of the set contain self-lubricating
bearings and must not be oiled or lubricated.
AZ 1570 /17
page
11
English
AZ 15
70
CD RA
DIO C
ASSET
TE RE
CORD
ER
OPE
STOP
PLAY
•PAU
SE
TUNE
R
PRESE
T
PROG
SHUF
FLE
REPE
AT
SEAR
CH
BAND
SOUND CONTR
OL CENTER
FM
AM
BAT
LOW
LW
PROG
SHUF
FLE
•
•
VOL
AZ157017 15-12-2000 18:30 Pagina 11