Philips DVD711-173 - Manual (Page 12)

16
Connecting to an amplifier equipped with Dolby
Surround™
Dolby Surround sound
1 Connect the player to the TV, then connect the player’s audio Left and
Right out jacks to the corresponding in jacks on the Dolby Surround™
Audio/Video receiver, using the audio/video cable supplied (D).
If your amplifier is equipped with a Dolby Digital™ decoder,
● Connect the player as described in ‘Connecting to an A/V receiver with
multi-channel decoder’.
If your TV is equipped with a Dolby Surround™ decoder,
● Connect the player to the TV as described in ‘Connecting to a TV’.
Connecting the power cord
1 Plug the female end of the supplied power cord into the Mains (AC) jack
on the rear of the player.
2 Connect the other end of the cord to an AC outlet.
Note: When the player is in the “STANDBY” mode, it is still consuming some power.
If you wish to disconnect your player completely from the power, unplug the power
cord from the AC outlet.
Caution: Only qualified service personnel should remove the cover
or attempt to service this device.
Remote control battery installation
Loading the batteries
1 Open the battery compartment cover.
2 Insert batteries as indicated inside the battery compartment.
3 Close the cover.
Caution: Do not mix old and new batteries. Never mix different
types of batteries (standard, alkaline, etc.).
NTSC/PAL Settings
You can switch the NTSC/PAL setting of the DVD player to match the video
signal of your TV. This setting only affects the television’s on-screen display
that shows the stop and setup modes. You may select either NTSC or PAL. To
change the DVD player setting to PAL or NTSC, follow the steps below.
1 Unplug the DVD player from the mains.
2 Press and hold
9 and T on the front of the DVD player. While holding
9 and T plug in the mains.
3 After PAL or NTSC appears on the display panel of the DVD player,
release
9 and T at the same time. The PAL or NTSC that appears on
the display panel indicates the current setting.
4 To change the setting, press
T within three seconds. The new setting
(PAL or NTSC) will appear on the display panel.
PREPARATION
L R (CVBS)
VIDEO OUT DIG OUT AUDIO OUT S-VIDEO OUT OPT OUT
DIGITAL AUDIO OUT PCM/MPEG2/AC3/DTS STEREO OUT
(Y/C)
I
AUX/VCR IN
II
TV OUT
MAINS
TV
C B A D
+ - + -