Philips SHC1300-61 - Manual (Page 6)

Installation Audio Connections
6
English
Headphone battery
replacement (figure 3)
1 Open the headphone’s battery
compartment.
2 Take out the batteries and dispose of
them properly.
3 Insert new batteries.
4 Make sure the batteries are correctly
inserted as indicated by the engraved
symbols in the battery compartment.
5 Close the battery compartment.
Audio Connections
Connecting the FM transmitter to
a headphone output of an audio
source (figure 4)
1 Connect the 3.5 mm stereo plug of the
stereo audio cable to the headphone
output of an audio source, such as TV,
HiFi or PC.
– In case your audio source has a
6.3 mm headphone output, use the
supplied 3.5 mm to 6.3 mm stereo
adapter plug.
2 Switch on your audio source and
carefully increase the volume of the
audio source.
3 Switch on the headphone and the
transmitter.
4 Adjust the volume to the desired level
with the headphone volume control.
Basic operation
When the IR transmitter is connected to
a headphone output of an audio source.
1 Switch on your IR transmitter and place
it at the same height or slightly higher
than the reception height of the IR
headphone.
2 Position the LED’s towards the listening
area, ensuring that there are no
obstacles in between transmitter and
headphone.
3 Switch on the headphone.
4 Switch on your audio source and
carefully increase the volume of the
audio source.
5 Adjust the volume of the IR headphone
to the desired level with the headphone
volume control.
IMPORTANT
Because IR light travels in a straight
line, place the IR transmitter at the
same height, or slightly higher than
the reception height of the IR
headphone.
High IR light content such as
sunlight and bright incandescent
indoor lighting may degrade the
audio signal and cause interference.
If you experience such problems,
simply move the system to a darker
area.
SHC1300_booklet 12-01-2006 11:08 Pagina 6