Philips 51PP9100D-37B - Manual (Page 7)

7
O
PERATING THE
T
ELEVISION AND
R
EMOTE
C
ONTROL
Using the Remote Control
PIP
2 13
5 46
8 79
0
TV SWAP PIP CH DN UP FREEZE
SOUND
MUTE
SURF A/CH
POWER
PICTURE
STATUS/ EXIT
POSITION
VCR ACC
MENU/
SELECT
VOL CH
TV/VCR
ACTIVE CONTROL
U
SING THE
TV B
UTTONS
S hould your remote control be lost or broken, you can still change
some of the basic picture and sound settings with the buttons on
the TV. Follow the steps below to familiarize yourself with the
functions of the TV buttons.
1 Press POWER/STANDBY to turn the TV on (or off). Allow
about 10 seconds for the TV to power on.
2 Press the VOLUME + or – buttons to decrease or increase
the sound level.
Press the VOLUME + and – buttons simultaneously to
display the onscreen menu. After the menu appears, use
these buttons to enter submenus and make selections or
adjustments. (Use the CHANNEL buttons to move up and
down in the menu or submenus.) Press both VOLUME
buttons simultaneously to back out of the onscreen menus.
3 Press SOURCE SELECT to choose from among the signal
inputs you have connected to the TV.
4 Press the CHANNEL buttons to select TV channels.
T
ELEVISION
R
EMOTE
C
ONTROL
I NSTALLING B ATTERIES
T o load batteries into the remote, follow these steps.
1 Gently press the tab on the battery cover on the back of
the remote and lift the battery cover off the remote.
2 Place the two “AA” size batteries in the remote’s
battery case. Ensure that the (+) and (–) ends of the batteries
line up correctly with the (+) and (–) inside the case.
3 Press the battery cover back into place.
Note: When operating the remote control, point the remote toward
the remote sensor window on the TV.
To prevent battery leakage that may
result in injury to you or damage to the
remote control:
• Install ALL batteries correctly, + and –,
as marked on the unit.
• Do not mix batteries (OLD and NEW or
CARBON and ALKALINE, etc.)
• Remove batteries when the remote
control is not used for a long time.
Do not take apart, heat, or put batteries
in fire.
Remote Sensor
Window
B
ATTERY
U
SAGE
CAUTION
• Be sure to point the remote toward the
sensor window on the TV.
• Be within about 30 feet (10 meters) of
the TV.
• Avoid dropping the remote on hard
surfaces.
• Do not use harsh chemicals to clean the
remote. Use only a soft, lightly mois-
tened cloth.
H
ELPFUL
H
INTS
Power Standby
Button
You can press any of the buttons on the front of the TV
to turn the TV on, but you must press thePower/Standby
button to turn the set off.
H
ELPFUL
H
INT