Philips HX6731-02 User Manual

Page 7

Flashing yellow: less than 10%

Standard charge indicator (select models):

Solid green: 50-100%

Flashing green: less than 50%

Note: When the battery of your Sonicare is low, you hear 3 beeps after the

completion of the brushing cycle and the battery charge indicator fl ashes for

30 seconds.

Note: To keep the battery fully charged, you may keep your Sonicare on the

charger when not in use. It takes 24 hours to fully charge the battery.

Using your Sonicare

Brushing instructions

Wet the bristles and apply a small amount of toothpaste.

Place the toothbrush bristles against the teeth at a slight angle

towards the gumline.

Press the power on/off button to turn on the Sonicare.

Apply light pressure to maximize Sonicare’s effectiveness and let the

Sonicare toothbrush do the brushing for you.

Gently move the brush head slowly across the teeth in a small back

and forth motion so the longer bristles reach between your teeth.

Continue this motion throughout your brushing cycle.

Note: To make sure you brush evenly throughout the mouth, divide your mouth

into 4 sections using the Quadpacer

feature (see chapter ‘Features’).

Begin brushing in section 1 (outside top teeth) and brush for 30

seconds before moving to section 2 (inside top teeth). Continue

brushing in section 3 (outside bottom teeth) and brush for 30

seconds before moving to section 4 (inside bottom teeth).

After you have completed the brushing cycle, you can

spend additional time brushing the chewing surfaces of your teeth

and areas where staining occurs. You may also brush your tongue,

with the toothbrush turned on or off, as you prefer.

Your Sonicare is safe to use on:

Braces (brush heads wear out sooner when used on braces)

Dental restorations (fi llings, crowns, veneers)

Note: The toothbrush may be turned off at any time by pressing and holding

the power on/off button for 2 seconds.

ENGLISH