Hyundai H-1405 - Manual (Page 7)

7
· Press the PROG button to confirm.
· Repeat steps described above to enter additional memories into the program if necessary.
· When all the desired tracks have been programmed, press PLAY button to play the disc in the order you have programmed.
· To stop the CD, press the STOP button.
NOTE: The program memory will be cleared only when the CD compartment is opened or turn off the CD or power supply.
· To remove the CD from the unit open the CD door.
· To turn off the CD player set FUNCTION switch to TAPE position.
MP3 operation
· Set FUNCTION switch to CD (MP3) position.
· Open the CD door. Put a MP3 disk into the CD compartment and close the CD door.
· The disk will spin and perform a full check of the disc to count the total number of songs. Then playback of the first song (track) will begin and the
display will indicate the current track no: (001).
· At any time during playback, press and release BACK AND NEXT buttons to skip backwards or forwards by one track.
· MP3 discs often have folder (sub-directories) which contain groups of songs.
· If your MP3-CD has no folders, you can use the "skip +10/folder" button to jump 10 songs ahead.
· If your MP3-CD has folders, you can select the folder to playback by pressing the "skip +10/folder" button.
· Each time you press the "skip +10/folder" button, the player jumps to the first song in the next folder.
Note: Good quality sound is guaranteed only when playing licensed MP3 discs.
Dynamic Bass Boost system
· The built in "super bass booster" circuit provides a powerful enhancement to low frequency music, giving a stronger bass sound which is ideal for "rock"
or "jazz" music.
· For increased bass at all volume levels, set the DBBS switch into On position for an emphasized bass sound.
Maintenance and care
· Check your batteries regularly, old or discharged batteries should be replaced. If the unit is not going to be used for some time or is being run exclusively
on the alternative power, remove the batteries to avoid leakage and damage.
· Electronic products of this kind should never be subjected to moisture or extreme temperatures.
· If necessary, clean the unit with a piece of cloth dampened with water only (be sure the AC power cord is disconnected from the power supply).
· The heads and capstan are in constant contact with the moving tape. Use a small cotton bud with alcohol or special tape head cleaner to clean these parts.
Never touch the heads with anything metallic.