Philips RWSS5512-00 - Manual (Page 6)

4 EN
Connect rear speakers to
wireless receiver
Note
• The rear speakers in the picture showed may vary.
Connect the rear left and rear right speakers
to the matching connectors at the back of the
wireless receiver.
Connect power cord
Warning
• Risk of product damage! Ensure that the power
supply voltage corresponds to the voltage
printed on the back or the underside of the
product.
Connect the power cords for home theater,
wireless receiver and other devices after you have
made all of the other connections.
» The wireless indicator lights and the
wireless receiver is ready to use.
REAR
LEFT
REAR
RIGHT
3 Troubleshooting
Follow these steps if:
• there is no sound from the rear speakers, and
• the indicator on the wireless receiver blinks
continuously for more than one minute.
For Blu-ray home theater
1
Connect the home theater, wireless
transmitter, and wireless receiver correctly
(see 'Connect' on page 3).
2
Insert a pin into the pairing pinhole at the
back of the wireless receiver.
» The indicator on the wireless receiver
blinks for thirty seconds. Complete the
remaining steps within thirty seconds.
3
Switch the home theater to either AUX
source or MUSIC iLINK source.
4
Press and hold the Navigation button
(right) until PAIRING (PAIRING) blinks on
the home theater display panel.
» 'PAIRED (PAIRED) is displayed.
• If FAILED (FAILED) is displayed, repeat
steps 1 to 3.
For DVD home theater
1
Connect the home theater, wireless
transmitter, and wireless receiver correctly
(see 'Connect' on page 3)..
2
Insert a pin into the pairing pinhole at the
back of the wireless receiver.
» The indicator on the wireless receiver
blinks for thirty seconds. Complete the
remaining steps within thirty seconds.
3
Press .
4
Press 1, then press SURR within five seconds.
» PAIRED' (PAIRED) is displayed.
• If FAILED (FAILED) is displayed, repeat
steps 1 to 3.