Philips VR220CAT99 - Manual (Page 20)

SELECT op CHOOSE B
→ STATUS [ON]
COUNTER ONLY [OFF]
TO END PUSH EXIT
20 On-Screen Status Displays
• You may not access a status display
when viewing a still picture or dur-
ing forward or reverse searching.
• The status display may not appear
if a weak channel is selected and
BLUE BACKGROUND is set to OFF.
Details are on page 37.
Helpful Hints
1
Press the VCR button, then press the MENU button.
Current status
of tape
Time
Channel
Counter
and
Counter
Memory Tape
Speed
STOP 12:00 AM
CH10
SLP M 1:23:45
A status display will appear when you press the STATUS/EXIT button
or certain function buttons. The contents of the status display will
vary. To choose the status display mode, follow the steps below.
If you select STATUS ON, then select COUNTER ONLY
ON:
● Whenever you press the STOP/p button or the PLAY/o button,
the status display will appear for five seconds. After five seconds,
only the counter will remain on the screen. You must press the
STATUS/EXIT button to remove it. Portions of the status display
also may appear when you press other function buttons.
If you select STATUS ON, then select COUNTER ONLY
OFF:
● Whenever you press the STOP/p button or the PLAY/o button,
the status display will appear for five seconds. Portions of the status
display also may appear when you press other function buttons.
If you select STATUS OFF:
● The status display will not appear when you press function buttons.
You must press the STATUS/EXIT button to see the status display.
2
Press the PLAY/o button or the STOP/p button to select
VCR SET UP, then press the F.FWD/B button.
3
Press the PLAY/o button or the STOP/p button to select
ON SCREEN MODE, then press the F.FWD/B button.
5
If you set STATUS to OFF, go to step 6. If you set STA-
TUS to ON, press the PLAY/o button or the STOP/p
button to select COUNTER ONLY, then press the
F.FWD/B button so that OFF (or ON) appears beside it.
6
Press the STATUS/EXIT button.
4
Press the PLAY/o button or the STOP/p button to select
STATUS, then press the F.FWD/B button so that OFF
(or ON) appears beside STATUS.
Status Display
(example only)