Philips CLON99BK - Manual (Page 4)

4
SMART
PLUG
75 Ω
ANT/
CABLE
POWER
1
2
4
EXTERNAL
SPEAKER
3
SMART PLUG
75 Ω ANT/ CABLE
EXTERNAL SPEAKER
C
ONNECTING THE
C
LON
99-BK S
MART
L
OADER
Optimum Performance of the
Clon99-BK SmartLoader box
is obtained by plugging it into
an ITV set that is already
turned on.
Press the POWER button to turn
the ITV ON.
Plug one end of the cable into the
jack provided on the Clon99-BK
SmartLoader.
Plug the other end into the jack
provided on the back of the TV. The
TV’s jack is next to the Antenna
Input terminal and may be labeled
various ways such as; Smart Port,
Clone Port, etc.
Push the Slide Switch to the ON
position. The red LED should light.
(If the TV is turned off, it should
turn on within 15 seconds.)
Within 20 seconds, the Clon99-
BK SmartLoader on-screen display
should appear. If the display does not
appear, check the connections and
push the Slide Switch to the ON
position again. If there is still no
response from the SmartLoader,
replace its 9-volt battery.
Once the Clon99-BK
SmartLoader on-screen display
appears, press the POWER button on
the RG4172BK (T374AH) Remote
Control. The SmartLoader Setup
Menu should appear.
Clon99-BK SmartLoader Connection
Power button on the front of an ITV.
BEGIN
Clon99-BK
SmartLoader
Cable
Rear jack panel
of ITV
Clon99-BK SmartLoader
ON/OFF slider switch
LED
PHILIPS
SMARTLOADER 99
Copyright PCEC 1999
System Version D.0
PN 3135 019 01681
PRESS POWER TO BEGIN
5 6
Philips SmartLoader 99
System Version D.0
1 - Read TV
2 - Write TV With Settings
3 - Write TV Without Settings
4 - Erase SmartLoader Memory
5 - System Test
6 - Exit SmartLoader
Stored Memory Type 01, 04
LIGHT
SLEEP
CH
RECALL
POWER
SELECT
1
2
3
4
5
6
7
8
9
0
POWER GUEST
SETUP
SETUP
VOL
M
؀
؁
A/CH
MUTE
CC
RESET
CD GD E TV
TV
DCM
F
E
G C
B
D
A
6
Press the POWER button
on the remote control.
Clon99-BK SmartLoader
On-Screen Display Clon99-BK SmartLoader
Setup Menu