Operating instructions – Bravetti CM80H User Manual

Page 6

OPERATING INSTRUCTIONS

Control Panel Features

Familiarize yourself with the control panel

before using your coffee maker.

Fig. 1

7. Advanced Timer Indicator Light

This timer indicates that the coffee

maker is in a delayed brewing cycle.

To verify what time the brew cycle will

begin depress the advanced timer

button.

8. Power “On” Indicator Light

This light indicates that the unit is

turned on.

9. Brew Strength Indicator Light

This indicator lights up when the brew

strength feature has been selected for

brewing.

How to Set the Clock

When the unit is first plugged in, the

display will read 0:00 and begin to flash.

To set the correct time of day:

1. Press and hold the set hour button until

the correct hour is displayed.

2. Press and hold the set minute button

until the correct minute is displayed.

NOTE: Unplugging the unit will reset the

clock to “0:00” and flashing will resume.

Preparing Your Coffee Maker

Before using the coffee maker for the first

time:

1. Carefully unpack the coffee maker and

remove all packaging materials.

2. Thoroughly clean the carafe, carafe lid,

and filter basket with warm, soapy

water. Rinse well and dry.

CAUTION: Do not use harsh or abrasive

cleaners as this could damage the glass

carafe.

3. Wipe the warming plate with a clean

damp cloth.

WARNING: DO NOT immerse the coffee

maker in water or other liquids.

4. Before brewing your first pot of coffee,

run a full carafe of cold water through

the system 2 or 3 times, without a filter

or coffee grounds. This will remove any

dust or sediment that may have settled

in the components during the shipping

process.

Using the Coffee Maker

Select a level, flat surface to place the

coffee maker, preferably near an outlet.

1. Replace the lid after cleaning and

ensure that it is secured to the carafe.

2. Replace the filter basket into the filter

basket compartment.

3. Lift up the hinged water reservoir cover.

4. Fill the glass carafe with as much water

as is needed for the amount of

servings.

5. Empty the water from the carafe into

the illuminated water reservoir. The

water window indicates how much

water is in the reservoir. (Fig. 2)

6. Close the water reservoir cover.

7. Place the glass carafe with the lid in

place onto the warming plate.

CAUTION: The small opening at the rear

of the illuminated water reservoir prevents

accidental overflow of coffee into the filter

and or carafe. Do not overfill the

illuminated water reservoir.

Putting in the Coffee

1. Press the filter basket door release

button and insert a #4 cone shaped

paper filter into the filter basket.

2. Fill the filter with the required amount of

coffee depending on amount. (Fig. 3)

Fig. 2

Fig. 3

Tip: When you use a paper filter, it is

important that the filter fit flush against the

sides of the filter basket. If the filter

collapses, for best results, dampen the

filter before placing it in the filter basket

and adding the ground coffee.

3. For best results use coffee that is

ground for use with automatic drip

coffeemakers. (See chart below for

suggested amounts)

1. Digital Clock/Advance Timer

Display
A 24 hour clock display and display for

the advance timer feature.

2. Set Hour Button

This button allows you to set the clock

for the hour time and to pre-program

the coffee maker’s advance timer hour.

3. Set Minute Button

This button allows you to set the clock

for the minute time and to pre-program

the coffee-maker’s advance timer in

minutes.

4. Advance Timer Button

This button programs the coffee maker

up to 24 hours before the desired

brewing time. Hold down this button

while adjusting the time – hour and

minutes to begin the advance timer

action.

5. Brew Strength Button

The brew strength button is used to

enhance the flavor of the coffee.

6. Auto/Power “On” Button

This button controls three modes:

A. Auto Mode

Depress this button once to activate

the Auto Mode. Use to set the

advance timer.

B. Power “On” Mode

Depress twice to activate the

Power “On” Mode. This begins the

brew cycle immediately.

C. Power “Off” Mode

Depress three (3) times to activate

the Power “Off” Mode. This shuts

off the unit completely, including the

warming plate.

One Cup = Five ounces brewed coffee

1.5

TABLESPOONS

NUMBER OF CUPS

4. Swing the filter basket door closed until

it snaps into place.

CAUTION: Do not operate your coffee

maker if the door does not close

completely. If the door does not close

completely, check to see that the filter

basket is properly seated, and snap the

door back into place.

5. Depress the auto/power button twice

(2x) to activate the brew cycle.

Advance Timer Mode

1. Press and hold the advance timer

button, while continuing to hold the

advance timer button– press the set

hour button until the desired brew time

hour is displayed.

2. Press the set minute button until the

desired minute has been displayed.

3. Release the advance timer button.

4. Press the auto/power button once, the

advance timer “On” indicator light will

illuminate. This indicates that the coffee

maker is waiting for the preset brew

time to be reached before it will begin

the brew cycle.

CAUTION: If the auto/power “On” button

is pressed before the advance timer

button, the advance timer mode will not

activate.