Philips 27PT9007D-17 - Manual (Page 8)

T
FIRST
TIME YOU TURN ON THE TV
H
ELPFUL
H
INTS
ANTENNA : If you have an off-air or roof-top
antenna, select Antenna.
CABLE : If you have subscribed to cable signal from
any cable company, or you are receiving free-to-air
cable channels through your wall connection select
Cable.
The first-time installation will install both Digital
and Analog channe ls.
Please connect Antenna or
Cable to TV.
Select TV signal by or
arrow key and press ok
Press OK to launch the Auto
Channel Search.
Follow the instructions on this screen to start auto installation:
Press CURSOR or to select Antenna or Cable.
Press OK button to confirm and start auto installation.
8
VIRGIN MODE
Signal Type Antenna
AUTO CHANNEL SEARCH
Go Back
Signal Type Antenna
Analog Channel 69
Search percent 83
Digital Channel 4
Start Running
Installation may take about
30 min.
OK
he first time you turn on the new TV set, you will see a scree
n that helps you to auto install the programs.
Auto
installation starts with the analogue channels followed by the digital channels. The time taken for installation
depends on the number of channels available. You can stop the first auto installation by pressing the POWER
button on the remote control.
The auto installation is stopped and the TV goes into standby mode. Any channels
that have alread
y been found are stored.
Note : This screen will only appear the first time you turn on the TV. If you wish to auto install programs later,
please follow the procedure
on the next page (page 9).