Philips SWS2100W-27 - Manual (Page 3)

English
1 Introduction
Your Video RF Modulator is designed to convert the separate audio and
video signals (from a video camera, computer, portable VCR, satellite receiver,
DVD player, etc.) into normal VHF TV signals that you can see on any regular
TV set.
B Warning
For indoor use only; to reduce risk of fire or shock hazard,
do not expose this product to rain or moisture.
CAUTION
RISK OF ELECTRIC SHOCK.
DO NOT OPEN.
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT
REMOVE COVER OR BACK. NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED PERSONNEL.
This symbol is intended to alert you to the presence
of uninsulated dangerous voltage within the RF
Modulator’s enclosure that might be of sufficient
magnitude to constitute a risk of electric shock. Do
not open the RF Modulator’s case.
This symbol is intended to inform you that important
operating and maintenance instructions are included in
the literature accompanying this RF Modulator.
2 The FCC wants you to know
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesirable operation.
Even under optimum conditions, your Video RF Modulator may cause
undesirable interference. We suggest the following methods for trouble
shooting:
1 Use an AC outlet that is not the same circuit as the receiver.
2 Place the RF Modulator in a location further away from your
receiver. In the event that interference still occurs after the above
steps have been taken, you are required by FCC regulations to
discontinue use of this product.
3 Important safety information:
1 Before beginning installation of your Video RF Modulator read all
instructions and follow exactly throughout the installation.
2 After installation is complete, keep all instructions in a safe place so
they may be referred to in the future if necessary.
3 Please note the ideal environment for this device is on a hard flat
surface away from all heat sources and moisture.
4 Parts required
You need the following items, not supplied with your Video RF Modulator, to
connect it between a video input source (video game, video camera, satellite
receiver, DVD player, etc.) and your TV.
• Two 75-ohm coaxial cables with F-type connectors
• If your TV does not have a VHF 75-ohm F-connector, you will also
need a 75-ohm-to-300-ohm matching transformer
• One video shielded cable with RCA Plugs and one audio (stereo)
cable with RCA Plugs OR Dubbing Cable for VCR/DVD with RCA
Plugs OR 3 shielded cables with RCA Plugs
• One S-Video Cable