Philips SHB7110-37 - Manual (Page 16)

1
8 Using more of your
Philips Tapster Bluetooth
stereo headset
8.1 Learn about the battery status
Immediately after turning the headset on, the
LED will indicate the battery status.
LED behaviour Battery status
3x red blinking Less than 25% of charge
remaining
2x red blinking Less than 50% of charge
remaining
1x blue blinking 50% or more of charge
remaining
Approximately five minutes before the battery
runs out you will hear two short beeps every
minute to remind you to end the call or transfer
it to your phone before the battery runs out.
The LED will also continuously flash red with
about five minutes of talk time remaining.
8.2 Learn about simultaneous use for
voice and audio
Your Bluetooth stereo headset can connect to
one Bluetooth audio source (supporting the
A2DP and AVRCP Bluetooth profile) and one
Bluetooth communication source (supporting
HFP or HSP Bluetooth profile) at the same time.
Therefore you can connect your Bluetooth
stereo headset
• with a Bluetooth stereo enabled phone to
both listen to music and lead calls, or
• with a Bluetooth phone that only supports
Bluetooth communication (i.e. does not
support Bluetooth stereo (A2DP)) to lead
calls and at the same time to a Bluetooth
stereo device (Bluetooth enabled MP3 player,
Bluetooth audio adapter etc.) to listen to
music. Make sure to pair the phone first
with your Bluetooth headset, then turn both
the phone and headset off to then pair the
Bluetooth audio device.
With the SwitchStream feature you can listen to
music and monitor your calls at the same time.
While listening to music, you will hear a ring
tone when receiving a call and can switch to the
call simply by tapping the earpiece.