Philips SCD520-00 User Manual

Page 13

Leave the parent unit in the charger until the battery pack is fully

charged.

During charging, the charging light on the charger lights

up continuously.

When the battery pack is fully charged, the display of the parent unit

shows a full battery symbol T .

When you charge the parent unit for the fi rst time or after a long

period of disuse, switch it off and let it charge continuously for at least

10 hours.

Charging normally takes 8 hours, but it takes longer when the parent

unit is switched on while charging. To keep the charging time as short

as possible, switch off the parent unit during charging.

When the battery pack is fully charged, the parent unit can be used

cordlessly for at least 24 hours.

Note: When the parent unit is charged for the fi rst time, the operating time

is less than 24 hours. The battery pack only reaches its full capacity after you

have charged and discharged it four times.
Note: When the parent unit is not connected to a power outlet or even when

the parent unit is switched off, the battery pack gradually discharges.

Using the appliance

Use the baby monitor for its intended household use as described in this

manual.

Place the parent unit and the baby unit in the same room to test the

connection.

Make sure the baby unit is at least 3 feet/1 meter away from the parent

unit.

Press and hold the on/off button 3 on the baby unit until the green

power-on light goes on.

Note: The power-on light always lights up green, even when there is no

connection with the parent unit.

The nightlight lights up briefl y and then goes out again.

The battery light T lights up briefl y and then goes out again.

ENGLISH

4222.002.7190.1.indd 13

03-09-2008 14:30:56