Philips SE7452B-37 - Manual (Page 33)

31 Advanced settings
8.4.2 To modify Call Barring number
Press
m
MENU in idle mode, scroll
:
to
Advanced Set and press
m
SELECT, scroll
:
to Call Barring and press
m
SELECT.
Enter the Master PIN when prompted and
press
m
OK to confirm.
Note
By default, the Master PIN is 0000.
Scroll
:
to Barring Nr. and press
m
SELECT.
Scroll
:
to Number 1 , Number 2 , Number 3
or Number 4 and press
m
SELECT.
Enter the barring number (maximum 4 digits)
and press
m
OK to confirm.
• A validation tone is emitted and the screen
returns to previous menu.
Note
If a restricted number is dialled, the call will not
be connected. When this happens, the phone
emits an error tone and returns to idle mode.
8.5 Baby Call
When activated, the Baby Call feature enables
you to dial a number by pressing any key on your
handset. This feature is very useful for direct
access to emergency services.
You can enter up to 24 digits for baby call
number.
8.5.1 To activate Baby Call mode
Press
m
MENU in idle mode, scroll
:
to
Advanced Set and press
m
SELECT, scroll
:
to Baby call and press
m
SELECT.
Enter the Master PIN when prompted and
press
m
OK to confirm.
Note
By default, the Master PIN is 0000.
Press
m
SELECT to enter Mode .
Scroll
:
to On and press
m
SELECT to
confirm.
Enter the Baby Call number and press
m
OK to confirm.
• A validation tone is emitted.
8.5.2 To deactivate Baby Call mode
Long press
m
MENU (when Baby Call
mode has been activated before).
Enter the Master PIN when prompted and
press
m
OK to confirm.
Note
By default, the Master PIN is 0000.
Scroll
:
to Off and press
m
SELECT to
confirm.
8.5.3 To change Baby Call number
Press
m
MENU in idle mode, scroll
:
to
Advanced Set and press
m
SELECT, scroll
:
to Baby call and press
m
SELECT.
Enter the Master PIN when prompted and
press
m
OK to confirm.
Note
By default, the Master PIN is 0000.
Scroll
:
to Number and press
m
SELECT.
• The last stored Baby Call number is displayed
(if any).
Enter the baby call number (maximum 24
digits) and press
m
OK to confirm.
• A validation tone is emitted and the screen
returns to previous menu.
8.6 Registration
The procedures described below are the
procedures that you will find in your handset. The
procedures may vary according to the handset
you want to register. In this case, please refer to
the manufacturer of the additional handset.
Additional handsets must be registered to the
base unit before you can use them. Up to 6
handsets can be registered to one base station.
The Master PIN is required before you can
register or unregister handsets.
Note
By default, the Master PIN is 0000.
On the base station, press and hold
C
for
approximately 3 seconds.
• A validation tone is emitted.
On the handset, press
m
MENU, scroll
:
to Advanced Set and press
m
SELECT,
1
2
3
4
5
1
2
3
4
5
1
2
3
1
2
3
4
1
2