Philips MCM530-37B - Manual (Page 23)

23
English
Timer setting
The system can switch on to CD, TUNER or
USB PC LINK mode automatically at a preset
time, serving as an alarm to wake you up.
IMPORTANT!
– Before setting the timer, ensure that
the clock is set correctly.
– The volume of the timer will increase
gradually to the last tuned volume level.
If the last tuned volume level is too low,
the set will then increase to a
predetermined minimum audible level.
( 00 :00 / 12 :00AM )
( 00: 00 / 12: 00 AM )
4 ,
(CD / TUNER / USB PC LINK) 2
3
3
1
1
1
Press and hold TIMER on the remote until
icon starts flashing.
OR
Press and hold CLOCK•TIMER on the main
unit until "
SELECT CLOCK OR TIMER" is
displayed. Then press ë to change the display
to “ TIMER” and press
CLOCK•TIMER again to confirm.
2
Press CD or TUNER or USB PC LINK to
select the wake-up source.
➜ The selected source will be lighted while
other available sources are flashing.
3
Press à or á (for hours) and í or ë (for
minutes) repeatedly to set the wake up time.
4
Press TIMER (or CLOCK•TIMER) to store
the setting.
➜ The timer will always be switched on after it
has been set.
➜ icon remains on the display. It indicates the
timer is activated.
● At the preset time, the selected sound
source will be played for 30 minutes
before it switches to Eco Power standby
mode (if no button is being pressed within the
time frame).
➜
CD – playing the first track of the last
selected disc. If the last selected disc tray is
empty, it will switch to the next available disc.
If all the disc trays are not available, it will switch
to Tuner mode.
➜
TUNER – playing the last tuned radio station.
➜
USB PC LINK – playing the last selected
playlist. If the connection fails, it will switch to
Tuner mode. Refer to “USB PC Link” for proper
connection and setup before use.
Activating/Deactivating the timer
● Press TIMER ON /OFF on the remote to turn
off the timer or turn on to the last setting again.
➜ If activated, the timer information will display
for a few seconds, then the system resumes to
the last active source or stays in standby mode.
➜ If deactivated, “ OFF” is displayed.
Note:
– The system will exit timer setting mode if no
button is pressed within 90 seconds.
Checking the timer setting
●
Press TIMER on the remote.
➜ The timer information will display for a few
seconds, then the system resumes to the last
active source or stays in standby mode.
Timer Operations