Philips DCP852-37 - Manual (Page 12)

12
English
PREPARATIONS
Connections
Connecting headphones
Connect the headphones into the n1 or the n2 jack of
your set.
Connecting additional equipment
• Turn off your set before connecting to any addi-
tional equipment.
• You can connect the player to a TV or an amplifier to
enjoy DVDs or karaoke.
AV OUT
Connect the desired device to this terminal directly (no
setting needed in the DVD, iPod or SD/MMC mode).
AV IN
On the DVD player panel, press the source key repeated-
ly (AV on the remote) to select AV IN (AUX).
Connection Video Audio (Left) Audio (Right)
Color Yellow White Red
White
Red
Yellow
White
Red
Yellow
Remove the battery if the remote control is not to be used for a long time.
PREPARATIONS
Power supply
Using the AC / DC adaptor
Connect the supplied adapter to the set and the main
power supply (as shown).
TIP
To avoid damage to the player, switch off before plug-
ging or unplugging the AC adaptor.
Using the car adapter
Connect the supplied car adapter to the set and the
car cigarette lighter outlet.
TIP
• To avoid damage to the player, switch off before plug-
ging or unplugging the car adaptor.
• When connecting with car power (cigarette lighter) adaptor, be sure the
input voltage of the adaptor is identical with car voltage.
• Make sure the temperature is below 35oC when the DVD player is con-
nected to DC 16.0V in a car.
Powering your remote control
1
Push the iPod EJECT key to take out the remote con-
trol. Open the battery compartment. Remove the protec-
tive plastic tab (first time users only).
2 Insert 1 x lithium 3V battery, type CR2025, then close
the compartment.
✔
✔
CAUTION
- Batteries contain chemical substances, so they should be disposed of
properly.
- Danger of explosion if battery is incorrectly replaced. Replace only with
the same or equivalent type.
- Incorrect use of batteries can cause electrolyte leakage
and will corrode the compartment or cause the batteries to burst.
P001-022_DCP851_37_Eng 2008.2.15 11:27 Page 12