beautypg.com

Preparation, Setting the clock, Using the remote control – Philips MCM275-37 User Manual

Page 16

background image

16

English

Preparation

Setting the clock

After connecting MCM275 to the power supply,
set the clock first.

1

Press and hold

STANDBY-ON to switch the

set to Standby mode

The display shows the set time

-- --:-- -- flashes by default if you have not set

the clock

2

In the standby mode, press and hold

DISPLAY/

CLOCK on the remote control

SET CLOCK scrolls on the display

24 HR or 12 HR appears for the initial

clock setting. To select 24-hour clock or
12-hour clock,

On the remote control, press

VOLUME +/-

once or more (or turn

VOLUME on the

set)

On the remote control, press

DISPLAY/

CLOCK to confirm

The hours digits start flashing

3

Hold down or press

VOLUME +/- repeatedly

to set the hours (or turn

VOLUME on the

set)

4

Press

DISPLAY/CLOCK to confirm

The minutes digits start flashing

5

Hold down or press

VOLUME +/- repeatedly

to set the minutes (or turn

VOLUME on the

set)

6

Press

DISPLAY/CLOCK to confirm

– To exit without storing the clock setting press
STOP

9

Helpful hints:
– The clock setting will be erased when the system
is disconnected from the power supply.

– The set will exit from the clock setting mode if
no button is pressed within 90 seconds.

Using the remote control

IMPORTANT!

– Remove the
protective plastic tab
before using the
remote control.

– Always point the
remote control directly
towards IR area.

Notes for remote control:
– First select the source you wish to
control by pressing one of the source select
keys on the remote control (for example
CD, TUNER).
– Then select the desired function (for
example

ЙЕ

,

н

,

л

).

To replace the remote controls’
battery

CR 20

25

LIT

HIUM

2

3

1

CAUTION!
– Remove the battery if it is exhausted
or will not be used for a long time.
– Batteries contain chemical substances,
so they should be disposed of properly.

1

Press and hold 1 as indicated.

2

Simultaneously, pull the battery tray at 4.

3

Remove the old batter y and put a new CR2025
battery in place.

4

Put back the battery tray.

USB

/

P001-P031_MCM275_37_Eng

12/20/2005, 09:40

16

This manual is related to the following products: