Philips AZ101817 - Manual (Page 11)

If a fault occurs, first check the points listed below before taking the set for repair.
Do not open the set as there is a risk of electric shock.
If you are unable to remedy a problem by following these hints, consult your dealer or
service center.
WARNING: Under no circumstances should you try to repair the set yourself, as this
will invalidate the warranty.
Troubleshooting
16
English
Problem Solution
No sound – Adjust the VOLUME
No power – Power cord not securely connected. Connect AC
power cord properly
– Batteries dead /incorrectly inserted. Insert (fresh)
batteries correctly
Display does not function – Electrostatic discharge
properly/ No reaction to Switch off and unplug the set. Reconnect after a few
operation of any of the seconds.
controls
no d1SC, Cd Err or – No CD inserted, insert a CD
nF d1SC indication – CD badly scratched/ dirty. Replace/ clean CD (see
maintenance)
– CD-(R) is blank or the disc is not finalized.
Use a finalized CD-R(W)
– Laser lens steamed up. Wait until lens has acclimatized
Laser lens steamed up – Wait until lens has cleared
– Wait until lens has acclimatized
CD playback does not work – CD badly scratched/ dirty. Replace/ clean CD (see
maintenance)
The CD skips tracks – CD damaged or dirty. Replace or clean CD.
– Program is active. Quit program mode
Poor cassette sound quality – Dust and dirt on the heads, etc.
Clean deck parts, see maintenance.
– Use of incompatible cassette types (METAL or
CHROME). Only use NORMAL (IEC I) for recording
Recording does not work – Cassette tab(s) may be broken. Apply a piece of
adhesive tape over the missing tab space.
XP AZ 1018/17 14-11-2000 19:17 Pagina 16