Philips 32RF50S - Manual

1 3121 233 41301
ANT 75Ω L
Monitor out VIDEO
S-VIDEO
SURROUND SOUND
8 8
+ R – – L +
AV1 in
Y Pb Pr
AV2 in
AUDIO R
ANT 75Ω
IN OUT
1
2
Y our Cable TV input into
your home may be a
single (75 ohm) cable or a
converter box installation.
In either case, the connec-
tion to the TV is very easy.
Just put the threaded end of
the cable signal to the TV's
antenna plug and screw it
down finger tight.
C
ABLE
TV
C ABLE I NPUT /C ONVERTER
OR
OUT TO TV IN FROM ANT.
1
ANT 75Ω L
Monitor out VIDEO S-VIDEO
SURROUND SOUND
8 8 + R – – L + AV1 in Y Pb Pr
AV2 in
AUDIO R
ANT 75Ω
2
F ollow the steps to the
right to connect a basic
antenna or cable TV signal
to a VCR, and then the VCR
to the TV. For information
on other hookups (possible
when cable/descrambler
boxes are included), refer to
the owner’s manuals for the
VCR and the cable converter.
TV TO VCR
B ASIC C ONNECTION
If your Cable TV signal
is a single, round cable
(75 ohm), then you're ready to
connect to the TV.
If you have a cable converter
box, connect the cable TV signal
to the cable signal IN(put) plug
on the converter.
Connect the cable TV cable to the
ANTENNA/CABLE plug on the TV.
If you have a cable converter box,
connect the OUT(put) plug from the
converter to the 75
Ω (ohm) plug on the
TV.
Connect your anten-
na or cable TV signal to the
IN FROM ANT(enna) plug on
the VCR.
Connect the OUT TO
TV plug on the VCR to the
75
Ω (ohm) plug on the TV
(connecting cable supplied
with the VCR).
Back of TV
Round Cable
75 Ω (Ohm)
Cable TV Converter
Box Connection
Cable TV Company
Remember
to set the TV for the
type signal to which
you've just connect-
ed (see the “Tuner”
section on page 3).
To select only the
channel numbers on
your cable system,
see “Auto Program”
(page 3). If you use a
cable converter box,
set the TV to the
same channel as the
converter's CH 3/4
switch (on the back
of the converter).
S MART
H ELP
Cable TV Signal Input
Round Cable
75 Ω (Ohm) Supplied with VCR
Outdoor
VHF/UHF
Antenna
300 Ω (Ohm) to 75Ω (Ohm) Adapter
Cable TV signal
Back of TV
Refer to the owner's
manual included with your
VCR for other possible con-
nections and TV/VCR operat-
ing details.
OR
NOTE: The connecting cable
for the converter is supplied
by the cable TV company.
VCR
1
ANT 75Ω L
Monitor out VIDEO
S-VIDEO
SURROUND SOUND
8 8
+ R – – L +
AV1 in
Y Pb Pr
AV2 in
AUDIO R
ANT 75Ω
2
A combination antenna
receives normal broad-
cast channels (VHF 2–13
and UHF 14–69). Your
connection is easy because
there is only one 75
Ω
(ohm) antenna plug on the
back of your TV, and that’s
where the antenna goes.
A
NTENNA
C OMBINATION UHF/VHF Remember, be
sure to set the TV for
the type of signal to
which you've connected
(see the “Tuner” section
on page 3).
To set the TV to select
only the channel numbers
in your area, see how to
“Program” or “Add”
channels in memory on
page 3 (“Auto Program”
section).
Contact your dealer,
or call our Parts
Information Center at
1-800-851-8885 to order
the following acces-
sories:
• 300 Ω (ohm) to 75Ω
(ohm) adapter
• Combination
VHF/UHF antenna.
S MART
H ELP If your antenna has a
round cable (75 ohm) on the end,
then you're ready to connect it to
the TV.
If your antenna has flat, twin-
lead wire (300 ohm), you first need
to attach the antenna wires to the
screws on a 300- to 75-ohm
adapter.
Push the round end of the
adapter (or antenna) onto the
75
Ω (ohm) plug on the back of
the TV. If the round end of the
antenna wire is threaded, screw
it down finger tight.
300 Ω (Ohm) to
75 Ω (Ohm) Adapter
Combination VHF/UHF
Antenna
(Outdoor or Indoor)
Twin-Lead
Wire
Round Cable
75 Ω (Ohm) Back of TV
OR
NOTE: For homes with separate UHF and
VHF antennas, you will need an optional com-
biner to connect to the TV.
ANT 75Ω L Monitor out VIDEO S-VIDEO SURROUND SOUND 8 8 + R – – L + AV1 in Y Pb Pr AV2 in AUDIO R
U/V
Combiner
300- to 75-Ohm Adapter
Back of TV
T
ABLE OF
C
ONTENTS
Getting Started
Warning/Important Notice . . . . . . . . . . . . . .1
Basic Cable Television Connection . . . . . . .1
Basic Antenna Television Connection . . . . . . . . . . . .1
Basic VCR/Accessory Device Connection . . . . . . . . .1
Basic Television Operation . . . . . . . . . . . . . . . . . . . . .2
Basic Remote Control Operation . . . . . . . . . . . . . . . .2
How to Use the Installation Features . . . . . . . . . . .3-4
Using the Language Control . . . . . . . . . . . . . . . . . . .3
Setting the Tuner Mode Control . . . . . . . . . . . . . . . .3
How to Automatically Program Channels . . . . . . . . .3
How to Add and Delete Channels . . . . . . . . . . . . . . .4
How to Name (Label) Channels . . . . . . . . . . . . . . . . .4
How to set the AutoChron™ Feature (Clock) . . . . . .4
Quick Use and Setup Guide
12 1 2
3
4 5 6 7 8
9
10
11
B
ASIC
T
ELEVISION
C
ONNECTIONS
Quick Use and Setup Guide
IMPORTANT
NOTE: This owner's manual is used with several
different television models. Not all features (and
drawings) discussed in this manual will necessar-
ily match those found with your television set.
This is normal and does not require you contact-
ing your dealer or requesting service.
WARNING: TO PREVENT FIRE OR SHOCK
HAZARD DO NOT EXPOSE THIS UNIT TO
RAIN OR EXCESSIVE MOISTURE.