Installation, Application – Philips 2G350A2H User Manual

Page 3

INSTALLATION

System requirements
Hardware: a PC which supports the USB function and has a USB

outlet

Software: Windows system which suppor ts USB

(OSR2.1 or higher).

Installation of USB module

1. Turn off the monitor and unplug the power card
2. Remove the cover of “USB AY” at the back of the

monitor.

3. Inser t USB module into the slot
4. Fix the USB module to the monitor by screwing
5. Do not tighten the fixing nut excessively (use fingers

to tighten screws) If screwed too right, the unit may
not connect properly!

6. Plug-in the power cord and turn on the monitor.

To establish the USB connection

7. Inser t disk.
8. The two ends of USB cable attached are different.

Plug-in the flat end into the “upstream” outlet of the
USB module .

9. Plug-in the other end into the USB outlet of the PC .

10. Windows recognises two new pieces of hardware

-philips USB hub
-USB Human Interface Device

This last item is presented through a wizard.
Follow the “next” steps on screen (choose the
“recommended” options) until installation has been
finished.

APPLICATION



SEKR

keyboard

mouse

joystick

scanner

printer

phone / PBX

USB HUB