Philips Blu-ray home theater system HTS3106 - Manual (Page 15)

EN - 15
EN
4. CONNECTIONS
4.1. Placing the Speakers
The Philips Blu-ray Disc™ Home Theater is simple to install. However, proper system placement is critical to ensure an
optimum sound experience.
1. Place the main unit near to the TV.
2. Place the speakers system at normal listening ear-level and directly parallel to the listening area.
3. Place the subwoofer at the corner of the room or at least 1meter away from the TV.
D Note
• The placement diagram shown here is only a guideline that provides great system performance. You may find other
placement choices that are more suitable for your room layout that provide the sound experience you enjoy.
• To avoid magnetic interference, never position the front speakers too close to your TV.
• The rear speakers are labeled as REAR LEFT or REAR RIGHT.
• The front speakers are labeled as FRONT LEFT or FRONT RIGHT.
• For speaker setup, refer to “Speaker Setup” on page 33.
4.2. Connection to the TV
„ HDMI Connection (Supports up to 1080i (*1) , 1080p (*2) , 1080p/24 resolution.)
No analog audio connection required.
• Do not tilt the connector when inserting it into the HDMI jack, and make sure the shapes of the jack and the connector
are matched.
• When connected to an HDCP incompatible display device, the picture will not be displayed properly.
• Use an HDMI cable with the HDMI logo (a certified HDMI cable) for this connection. High Speed HDMI cable (also
known as HDMI category 2 cable) is recommended for better compatibility.
(*1)
1080i : Outputs video data with a frame rate of 30 frames per second.
(*2)
1080p : Outputs video data with a frame rate of 60 frames per second.
FRONT
RIGHT
FRONT
CENTER
REAR
RIGHT
REAR
LEFT
SUBWOOFER
LEFT
LAN
SUB- WOOFER FRONT CENTER REAR FRONT
SPEAKERS 4
HDMI OUT
VIDEO OUT
DIGITAL AUDIO IN
COAXIAL
AUDIO IN AUX
HDMI IN HDMI OUT
HDMI cable
(not supplied)
Your TV