Philips 20RF40S - Manual (Page 7)

7
T he basic Antenna, or Cable TV, to
VCR to TV connection is shown to the
right. For more information on other
hookups (possible when Cable
Converter/Descrambler boxes are includ-
ed) refer to your accessory VCR and
Cable Converter Owner's Manual for
details.
1 Connect your Antenna or Cable TV
signal to the IN FROM ANT(enna)
plug on the VCR.
2 Connect the OUT TO TV plug on
the VCR to the 75
Ω
plug on the TV
(connecting cable supplied with the
VCR.)
3 Set the VCR output to channel 3 or 4
using the channel switch on the back
of the VCR.
4 Turn the VCR and the TV ON using
the power button on each device.
5 Depending on which channel you
selected in step 3, tune the television
to that channel (3 or 4) using the CH
+ or – buttons or the numbered but-
tons on the remote control.
6 Your now ready to view a prerecord-
ed tape from the VCR. Or, view
cable/antenna channels by changing
the channels on the VCR.
B
ASIC
VCR
TO
T
ELEVISION
C
ONNECTION
When using this type of connection, be sure
to set the CH 3/4 switch on the back of the
VCR. Then when viewing a Prerecorded
tape in the VCR, tune the television to the
corresponding channel.
H
ELPFUL
H
INT
75 ⍀
75 ⍀
OR
OUT TO TV IN FROM ANT.
1
2
3 4
Channel
– VOLUME + CHANNEL
AUDIO VIDEO
3
3
4
4
5
6
Back of TV
VCR with Antenna
Input and Output
Twin
Lead Wire
300 to 75-ohm
Adapter
Outdoor or Indoor Antenna
(Combination VHF/UHF)
The combination antenna receives normal
broadcast channels 2-13 (VHF) and 14-69 (UHF).
VCR to TV Connection:
Jack Panel
Back of TV
Round 75
Ω
Coaxial Cable
Channel Output Switch
located on the back of the VCR