Philips US2-MANT950 - Manual (Page 3)

3
Antenna grounding and safety warning
1. Outdoor antennas and lead-in conductors from antenna to a build-
ing, should not cross over open conductors of electric light or
power circuits.They should be kept away from all circuits to avoid
the possibility of accidental contact.
2. Each conductor of a lead-in from an outdoor antenna should be
connected with an antenna discharge unit. Antenna dicharge units
(or Lightning Arrestors) should be located outside the building or
inside the building between the point of entrance of the lead-in and
the TV, and as near as practical to the entrance of the conductors
to the building.
Important Safety Notes
If you do not feel comfortable or competent to install this antenna we
recommend that you seek the assistance of a qualified professional
antenna installer.
Read the instructions for this device thoroughly before attempting
installation.
The installation or dismantling of any antenna near power lines is dan-
gerous. Each year hundreds of people are killed or injured while
attempting to install or service antennas. For your safety and proper
antenna installation, read and follow all safety precautions.
Choose an installation site for safety as well as performance.
All electric power lines, cable lines and telephone lines look alike.To
be safe, assume ANY overhead line can kill you.
Do not place an antenna where it could potentially fall on to, or blow
into a power line. If in doubt call your electric provider. Let them
review your site.
Outdoor antennas should be grounded with an approved lighting arrest-
ing device. Local codes may apply. Use 8 AWG or larger ground wire.
Height or other restrictions on antennas may apply to your installa-
tion depending on your proximity to an airport, or local ordinances.
Take the time to plan your installation procedure. Do all assembly
EN
Safety Instructions
IIM MP PO OR RT TA AN NT T
R RE EA AD D
B BE EF FO OR RE E
IIN NS ST TA AL LL LA AT TIIO ON N
NEC - National Electrical Code
* Antenna Discharge Unit is not required if lead in conductors are enclosed in a
continuous metallic shield that is permanently and effectively grounded.
GROUND CLAMP
ELECTRIC
SERVICE
EQUIPMENT
ANTENNA
LEAD-IN WIRE
ANTENNA
DISCHARGE
UNIT*
(NEC
SECTION
810-20)
GROUNDING
CONDUC-
TORS
(NEC SEC-
TION 810-
21)
GROUND CLAMPS
POWER SERVICE GROUND-
ING ELECTRODE
SYSTEM (NEC ART 250,
PART H)
TO EXTERNAL ANTENNA
TERMINALS OF PRODUCT
TO ROTATOR CONTROL UNIT