Philips DVP620VR-17 - Manual

There are many ways to connect your new DVD / VCR to your Television and other equipment.This Quick-Use
Guide shows the easiest, most common connection.
Higher quality connections are explained in the accompanying owner’s manual and will provide better sound or
picture if your TV and / or audio system is compatible.
REAR OF TV
(EXAMPLE ONLY)
ANTENNA IN RF COAXIAL CABLE
IN OUT
CABLE BOX
(Optional)
CABLE TV SIGNAL
ANTENNA or
CABLE TV SIGNAL
1 Disconnect all equipment from the power outlets. Connect the equipment to the power outlets only after you
have finished hooking up everything. Never make or change connections with equipment connected to the power outlet.
2 Connect your Antenna TV signal directly to the AERIAL jack on the rear of the DVD/VCR using an RF cable
(not supplied).
If you have a Cable Box (or Satellite Receiver), connect the OUT jack of the Cable Box/Satellite Receiver to the
AERIAL jack on the DVD/VCR using an RF coaxial cable (not supplied).
3 Connect the supplied black RF coaxial cable to the DVD / VCR’s ANT-OUT jack and to your TV’s ANTENNA
IN jack. The TV’s ANTENNA IN jack may be labelled 75-ohm,TV IN, or RF IN. Check your TV manual for details.
4 Plug the power cords of the DVD / VCR and the TV into an active power outlet.
5 Turn on the TV power. Set the TV to a video channel. (If you cannot use channel 3 at your TV, you can use
channel 4 instead. However, you must correspondingly set the DVD / VCR’s output channel 3 or 4. See the
accompanying DVD / VCR owner’s manual for details.)
6 Press the STANDBY-ON 2 button on the DVD / VCR or its remote to turn on the DVD / VCR. The first
time you turn on the DVD / VCR, you should complete the VCR setup. See the other side of this Quick-
Use Guide for details.
DVP620VR
- -
DVP620VR/17 QUG_rev2 28/05/2004 08:44 PM Page 1