Philips Hospitality LED-LCD TV 46HFL5784L 117cm-46" class b-LAN™ ProIdiom® MPEG-4 - Manual (Page 7)

7
46 42 39HFL5784D L
Channel installation
This section describes how to install the TV channels
automatically.
1
Connect the RF signal to the TV.
2
Plug the power cord into the power outlet.
Cable
3
Turn the TV on.
46HFL5784L, 42HFL5784D, 42HFL5784L
• Press . (POWER) at the rear of the TV or use the
. (POWER) on the remote control.
39HFL5784D, 39HFL5784L
• Press . POWER at the front of the TV or use the
. (POWER) on the remote control.
4
Press RC5 SETUP to put the remote control into setup
mode, then press the HOME/MENU button to display
the setup menu. (Hereafter, HOME/MENU will be
simply referred to as MENU)
5
Select Setup Menu - Channels - Autoprogram; then
select Cable. (unless the installation is using only Antenna
signals - in which case you would select Antenna)
LC11_PHILIPS_hospitality_EN_QG.indd 7 LC11_PHILIPS_hospitality_EN_QG.indd 7 2013/07/25 11:02:03 2013/07/25 11:02:03