Philips MCM275-37B - Manual (Page 3)

Prepare
Setting the clock
2
3
4
5
6
In the standby mode, press and hold DISPLAY/CLOCK on the remote control
➜ 12 HR or 24 HR appears for the initial clock setting. To select 24-hour clock or
12-hour clock,
a.
Press VOLUME +/- once or more
b. Press DISPLAY/CLOCK to confirm
➜ The hours digits start flashing
Hold down or press VOLUME +/- repeatedly to set the hours
Press DISPLAY/CLOCK to confirm
Hold down or press VOLUME +/- repeatedly to set the minutes
Press DISPLAY/CLOCK to confirm
Enjoy
1
2
3
4
5
Playing discs
With this system, you can play all pre-recorded audio CDs (CDDA), all finalized audio CD-Rs
and CD-RWs, MP3/WMA-CDs (CD-Rs/CD-RWs with MP3/WMA files)
Press SOURCE once or more to select CD (or CD on the remote control)
Press CD OPEN•CLOSE ç to open the CD compartment
Insert a disc with the printed side facing up. Press CD OPEN•CLOSE ç again
to close the compartment
Press ÉÅ to start playback
To stop playback, press STOP Ç
Notes for remote control:
– First, select the source you wish to
control by pressing one of the source
select keys on the remote control (DISC
or TUNER, for example).
– Then select the desired function
( 2;,
н, л for example).
IMPORTANT!
– Remove the
protective
plastic tab
before using
the remote
control
USB
/
USB
/
1
Press and hold STANDBY-ON y to switch the set to Standby mode
➜ The display shows the set time
➜ -- --:-- -- flashes by default if you have not set the clock
MCM275 QSG_-37-Eng 12/20/2005, 10:45 3