Philips RWSS5510-00 - Manual (Page 7)

7
English
4 Product
specifications
Note
• Specification and design are subject to change
without notice.
Wireless receiver
For RWSS5510
• Power supply rating: 110-240V; ~50-60 Hz
• Total output power: 250 W (RMS)
• Power consumption: 50 W
• Standby power consumption: ≤ 0.45 W
• Frequency response: 150 Hz ~ 20 kHz
• S/N Ratio: 65 dB (A-Weighted)
• Distortion: 1%
• Dimensions (WxHxD): 126 x 131 x 126
(mm)
• Weight: 1.1 kg
For RWSS9500
• Power supply rating: 110-240V; ~50-60 Hz
• Total output power: 300 W (RMS)
• Power consumption: 40 W
• Standby power consumption: ≤ 0.45 W
• Frequency response: 150 Hz ~ 20 kHz
• S/N Ratio: 65 dB (A-Weighted)
• Distortion: 1%
• Dimensions (WxHxD): 265 x 116 x 106
(mm)
• Weight: 1.4 kg
Wireless transmitter
• Frequency response: 5.8 GHz
• Dimensions (WxHxD): 55 x 53 x 33 (mm)
• Weight: 0.05 kg
3 Troubleshooting
Follow these steps if:
• there is no sound from the rear speakers,
and
• the indicator on the wireless receiver blinks
continuously for more than one minute.
For home theater with Blu-ray
1
Disconnect the power cord and the speaker
cables from the wireless receiver for one
minute, and place the wireless receiver near
the home theater.
2
Switch off the home theater and then
switch it on again.
3
Switch the home theater to either AUX
source or MP3 link source.
4
Connect the power cord for the wireless
receiver.
» The indicator on the wireless receiver
blinks.
5
Press and hold the Navigation button,
(right) until ‘PAIRING’ blinks on the home
theater display panel.
» ‘PAIRED’ is displayed.
6
Connect the speaker cables to the wireless
receiver.
» The wireless receiver is ready to use
again.
7
If ‘FAILED’ is displayed, repeat steps 1 to 6.
For other home theater
1
Disconnect the power cord from the
wireless receiver for a few seconds and
connect it back again.
2
Press .
3
Press INFO.
» A screen is displayed.
4
Press 1, then press SURR within five
seconds.
» ‘PAIRING SUCCESS’ is displayed.
5
If ‘PAIRING FAIL’ is displayed, repeat steps
1 to 4.
EN