beautypg.com

Ember stove log set placement for model 329 – New Buck Corporation 329 User Manual

Page 11

background image

EMBER STOVE LOG SET PLACEMENT FOR MODEL 329

MODEL E.S.B: 1)Rear Log, 2)Middle Log, 3)Left Top Middle Log, 4)Right Top Middle
Log 5)Left Front Log 6)Right Front Log 7)Glowing Embers in front of 5 & 6 logs.
WARNING: POSITIONING OF LOGS IS VERY CRITICAL (See Figure 2).
LOG PLACEMENT FOR E.V. 100 Series 24” OAK OR PINE LOG SET:

1) Place rear log #1 on rear log supports. The log has alignment notches on each rear corner.
2) Place Middle log #2 in front of the rear burner tube and then move the log forward. The log
should seat just behind the brass knob(s), located in the middle section of the base between the rear
burner tube and the front burner pan.
3) Place Left Top Middle log #3 on the pins located on the left top section of Middle log #2.
4) Place Right Top Middle log #4 on the pin located on the right top section of Middle log #2 and a

line the notch on the right side #4 with the side shield on the right.

5) Place Left Front log #5 on the locator pins located on the left middle section of the front burner

pan.

6) Place Right Front log #6 on the locator pins located on the right middle section of the front

burner pan.

7) Provided with your log set is a package of Glowing Embers (rock wool). Open the package and

tare off small pieces of the wool material and place it over the small holes (ports) located on the
front burner pan in front of logs #5 and #6. Cover the entire section of holes (ports).
*Replacement of loose (Glowing Embers) must be purchased from the original manufac-
turer and application of excess loose material may adversely affect performance of the
heater.

NOTE: “Wash your hands immediately after coming in contact with the wool material. The
wool can cause slight itching or burning in some cases, avoid any contact with eyes.”

“WARNING: All previously applied loose material must be removed prior to replacement.”

WARNING:

Failure to position the parts in accordance with these diagrams or failure to use only

parts specifically approved with this heater may result in property damage or personal injury.

WARNING:

POSITIONING OF LOGS IS VERY CRITICAL (SEE DIAGRAM ABOVE).

1

2

3

4

5

6

7

“MILLIVOLT ONLY”

Page 7