Philips DVDR3575H-37E - Manual (Page 55)

55 EN
Recording
Playback
Editing
Introduction
Connections
Basic Setup
Function Setup
Others
55 EN
Note for DV dubbing
• If you press [PAUSE F] at step 5, the tape will rewind to the point a few seconds preceding the paused point
when you press [OK] at step 6, then, it will start dubbing when it comes to the paused point.
• The unit does not send out the output signal to DVC.
• For the proper operation, connect DVC to the unit directly. Do not connect this unit and DVC via any other unit.
• Do not connect more than 1 DVC.
• The unit can only accept DVC. Other DV device such as cable/satellite box or D-VHS VCR cannot be recognized.
• If no video signal is detected from the DVC during DVC to HDD / DVD dubbing, the recording will be paused and
“I” will flash on the TV screen. The recording will resume when the unit detects the video signal again.
• When the DVC is in camera mode, refer to “Guide to DV and On-Screen Display” on page 53.
• Date / time and cassette memory data will not be recorded.
• Pictures with a copy-guard signal cannot be recorded.
• A DV terminal is a terminal that can use the transmission mode conforming to the IEEE 1394 standards called “Fire
Wire”. It enables digital dubbing between DV devices with little degradation.
• You cannot dub from DVC to the both HDD and DVD at the same time.
5 Press [PLAY B] to start playing back
the DVC, and find the point where
you wish to start dubbing.
Press [STOP C] when you come to the
desired start point.
6 Use [K / L] to select “Start Rec”, then
press [OK].
The dubbing will start.
To stop dubbing;
1) Use [K / L] to select “Control”,
then press [OK].
2) Use [K / L] to select “HDD” or
“DVD” (whichever the recording
component you are using), then
press [OK].
3) Press [STOP C].
DUBBING
E2H40UD_v4.indd 55 E2H40UD_v4.indd 55 2008/06/02 13:35:22 2008/06/02 13:35:22