SoundMax SM-2407 User Manual
Page 7
7
ss STOP/EJECT button to end recording.
rding from CD
CTION switch to CD/MP3/USB position.
ss RECORD button on cassette deck to start recording.
Select a track to be recorded. Press PLAY/PAUSE button to play the track.
Press PAUSE button if you want to interrupt recording. Press STOP/EJECT button to end recording.
Erase protection
To prevent accidental erasing of a cassette, simply break off the two plastic tabs located on the
cassette tape’s rear side.
When a cassette with removed plastic tabs is inserted, the recording button cannot be pressed.
If a cassette is to be erased and re-recorded at a later stage, simply cover the holes on the cassette
where the tabs were removed, with a piece of strong adhesive tape.
Maintenance and care
Check your batteries regularly; old or discharged batteries should be replaced. If the unit is not going
to be used for some time or is being run exclusively on the alternative power, remove the batteries to
avoid leakage and damage.
Electronic products of this kind should never be subjected to moisture or extreme temperatures.
If necessary, clean the unit with a piece of cloth dampened with water only (be sure the AC power cord
is disconnected from the power supply).
The heads and capstan are in constant contact with the moving tape. Use a small cotton bud with
alcohol or special tape head cleaner to clean these parts. Never touch the heads with anything metallic.
CD protection
When pick up the CD disc, always hold the edge of the disc, never touch the surface of the disc, it would
scratch the disc surface and may occur sound distortion or raise reading problem.