Philips 107E51-99 User Manual
Page 69
Regulatory Information
This monitor is equipped with a function for saving energy which supports the VESA Display
Power Management Signaling (DPMS) standard. This means that the monitor must be
connected to a computer which supports VESA DPMS to fulfill the requirements in the NUTEK
specification 803299/94. Time settings are adjusted from the system unit by software.
NUTEK
VESA State
LED Indicator
Power Consumption
Normal operation
ON
Green
Typical 64W
Power Saving
Alternative2
One Step
OFF
Flashing Green
< 1W
A
s an
E
NERGY
S
TAR
®
P
artner,
PHILIPS
has determined that this product
meets the
E
NERGY
S
TAR
®
guidelines for energy efficiency.
We recommend you switch off the monitor when it is not in use for quite a long time.
Federal Communications Commission (FCC) Notice (U.S. Only)
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
●
Reorient or relocate the receiving antenna.
●
Increase the separation between the equipment and receiver.
file:///D|/EDFU/crt_17_5/edoc/ENGLISH/107E/SAFETY/regs/regulat.htm (8 of 17)7/15/2004 5:30:02 PM