Philips 49PFL4909-F7 - Manual (Page 14)

Setting your Location to Home
You can set the Location of your TV to Home or Retail.
Choosing Home gives you full flexibility to change predefined
settings for Picture and Sound.
1
Display Setup using Home Menu and use HI to Select
Installation, then press OK.
Reset AV settings
Network settings assistant
Location
Autoprogram
English
Restore default settings
Network
Preferences
Channels
Language
Software
Installation
Features
Sound
Picture
Settings assistant
2
Use HI to Select Preferences, then press OK.
3
Use HI to Select Location, then press OK.
4
Use HI to Select Home, then press OK.
O Note(s)
●
You must set Home in the Menu. Otherwise, personalized
Picture and Sound Settings will Not Be Memorized after the Unit
goes into Standby Mode.
Viewing Photos, Playing Music and
Watching Videos on a USB Memory Stick
Your TV is fitted with a USB connection that enables you to
view photos, listen to music or watch video files stored on a
USB Memory Stick.
1
Press Q and use HIJK to select Browse USB, then
press OK.
2
Use HI to select the Picture, Music or Video, then
press OK.
● These Recorded Files must meet Specifications shown below:
Picture (JPEG)
Upper limit 16Mpixel
Music (MP3)
Sampling frequency 32 kHz, 44.1 kHz or 48 kHz
Constant bit rate 32 kbps - 320 kbps
Video (MPEG / VOB / AVI / MP4)
Maximum size
of a video
1920 x 1080
Extension .mpg, .mpeg .vob .avi .mp4
Video codec
Audio codec
MPEG1,
MPEG2
MPEG2
MPEG4 SP,
MPEG4
ASP
H.264,
MPEG4
Dolby Digital YES YES YES NO
MPEG1 audio
layer3 (MP3)
YES NO YES NO
MPEG1 audio
layer2
YES NO YES NO
LPCM YES NO NO NO
AAC-LC NO NO NO YES
O Note(s)
● This unit accepts USB Memory Stick only. Other storage devices
such as external HDD by USB Bus Power will not work.
●
Do not use an extension cord and USB Hub to connect devices
to this Unit. Always insert the USB flash memory in to this Unit
directly.
●
We cannot be held responsible if your USB Memory Stick is Not
Supported, nor will we accept any liability for damage or loss of
stored data.
●
The USB Memory Stick is Not Supplied with this TV.
● A maximum of 1,023 folders or files can be recognized.
● A file name exceeding 256 characters or contains a dot character
is Not Supported on this TV.
●
Progressive JPEG files are Not Supported.
5 Install Channels
Autoprogram
Be sure the RF cable is correctly connected to this Unit and
you are registered with your Cable TV provider when you
Install Cable channels.
1
Display Setup using Home Menu and use HI to Select
Installation, then press OK.
2
Use HI to Select Channels, then press OK.
3
Use HI to Select Autoprogram, then press OK.
4
Press OK to Select Start now.
● Autoprogram will start automatically.
0
0
Stop
complete.
Auto programming may take more than 20 minutes to
Analog channels found:
Digital channels found:
System searching. Please wait...
● If you run Autoprogram when you have Locked Channels, a
Message appears asking to enter your PIN. Enter your PIN in
order to Complete the Installation. You need to set the
Channel Lock again after the Installation.
● When the Scanning and Memorizing of Available Channels is
Completed, the Lowest Memorized Channel will be
Displayed.
5
Follow the On-screen Instructions to Complete the
Installation.
To obtain a more detailed electronic copy of this User Manual, go to www.philips.com/support
14