Philips 200W6CB-27 - Manual (Page 58)

Setting up and Connecting Your Monitor
If you use an Apple Macintosh TM , you need to connect the
special Mac adapter to one end of the monitor signal cable.
Connect the cables to the back of your computer by following these steps:
(a) Turn off your computer and unplug its power cord.
(b) Connect the VGA or DVI cable to the video connector.
(c) Connect the audio cable.
(d) Plug the power cord of the computer and the monitor into a nearby outlet.
(e)
Turn on your computer and monitor. If the monitor displays an image,
installation is complete.
Connect to Earphone
file:///D|/My%20Documents/dfu/200W6/english/200W6/install/connect.htm (2 of 3)2006-01-05 12:28:42 PM