Philips PPX2340-F7 - Manual (Page 8)

8 Philips · PPX2330 · 2340
3 Initial Operation
Setting up the Device
A tripod accessory is available if you want to elevate the
device.
Connect Power Supply /
Charge Battery
Connect the USB plug to a computer, to charge the bat-
tery. Alternatively you may connect the USB plug to the
power adapter (not included) (see also chapter Com-
patible Power Supply, page 23).
Initial Installation
1
Switch the device on using the on/off switch on the
side.
2
Turn the device towards a suitable projection sur-
face or wall. Note that the distance to the projection
surface must be a minimum of 1 foot and a maximum
of 6.9 feet. Make sure the projector is in a secure
position.
3
Use the focus wheel on the top to adjust the image
sharpness.
4 Select the desired menu language using ¡/¢.
5
Confirm with à.
CAUTION!
Electrical Voltage at the Site of Installa-
tion!
Check whether the electrical voltage of the
power supply matches the electrical voltage
available at the setup location. Note
The Main Menu Appears Instead of
the Language Selection
The device has already been installed. In
order to change the menu language, pro-
ceed as follows:
1
Use the navigation keys to select Set-
tings
.
2
Confirm with à.
3 Select with ¡/¢ Language.
4
Confirm with à.
5
Select the desired language with ¡/¢.
6
Confirm with à.
7
Exit with ¿.