Philips 42TA648BX-37 - Manual (Page 10)

ENGLISH
FRANÇAISE
ESP
AÑOL
EN-9
3.5 Manage cables
Route your power cord, antenna cable and all other device cables
through the cable holder at the back of the TV. This holder helps keep
your cables tidy and easily manageable.
3.6 Switch on and setup the TV
The TV switches on automatically after connecting the power cord.
Press the GREEN Next button located on your remote control to proceed.
Thank you for your purchase of this PHILIPS TV.
Please proceed with the following steps to set-up your TV. For the BEST
possible picture performance, contact your local Cable / Satellite signal
provider for High Definition signal options available in your area.
Next
Follow the on-screen instructions to select your language and complete
your TV setup. Installation takes approximately 10 minutes.
Note: D If you connect your TV to a cable box or satellite set-top
box, you do not need to install channels. Press the red button on
the remote control to exit the channel installation stage of the setup.
Finish the setup by selecting your location:
If you choose • Retail store your settings will be are erased each
time you turn off the TV. This mode is only to be used for retail
store displays.
If you choose • Home you are guided through a choice of picture
display options. Use the left and right cursor to select your
preferred screen.
TA64-DFU.indb 9 2008-03-26 1:34:10 PM