Bryan Boilers K Series - Manual (Page 4)

Bryan Indirect Pool Heaters
Form No. 640 © 2004 Bryan Steam LLC Printed in USA
44-5367
* Maximum outlet temperature for F series is 150°F; for DR, CLM, K and RV series, 160°. For outlet temperatures greater than those shown, consult factory.
† These units are equipped with two heat exchangers as standard and require a copper header to be field supplied.
F350-WP 280 576 16 x 36 40°F 23,000 350,000 350 NA 620
F450-WP 360 720 18 x 40 40°F 30,000 450,000 450 NA 765
F650-WP 520 1,000 20 x 50 40°F 40,000 650,000 650 NA 890
F850-WP 680 1,500 25 x 60 40°F 60,000 850,000 850 NA 1,155
DR350-WP 280 576 16 x 36 40°F 23,000 350,000 350 2.5 1,150
DR450-WP 360 720 18 x 40 40°F 30,000 450,000 450 3.2 1,250
DR650-WP 520 1,000 20 x 50 40°F 40,000 650,000 650 4.6 1,750
DR850-WP 680 1,500 25 x 60 40°F 60,000 850,000 850 6.1 1,850
CLM120-WP 960 1,800 30 x 60 40°F 84,000 1,200,000 1,200 8.6 3,200
CLM150-WP 1,200 2,250 30 x 75 40°F 92,000 1,500,000 1,500 10.7 3,600
CLM180-WP 1,440 3,000 40 x 75 40°F 123,000 1,800,000 1,800 12.9 4,050
CLM210-WP 1,680 3,465 42 x 80 40°F 137,000 2,100,000 2,100 15.0 4,475
CLM240-WP 1,920 4,050 45 x 90 40°F 143,000 2,400,000 2,400 17.1 4,900
CLM270-WP 2,160 5,000 50 x 100 40°F 160,000 2,700,000 2,700 19.3 5,525
CLM300-WP 2,400 6,000 60 x 100 40°F 184,000 3,000,000 3,000 21.4 5,930
K350-WP 2,800 6,600 60 x 110 40°F 217,000 3,500,000 3,500 NA 4,770
K400-WP 3,200 7,560 63 x 120 40°F 250,000 4,000,000 4,000 NA 5,180
K450-WP 3,600 8,400 70 x 120 40°F 275,000 4,500,000 4,500 NA 5,910
K500-WP † 4,000 9,750 75 x 130 40°F 320,000 5,000,000 5,000 NA 6,310
K550-WP † 4,400 12,000 75 x 160 40°F 400,000 5,500,000 5,500 NA 6,800
K600-WP † 4,800 13,200 80 x 165 40°F 445,000 6,000,000 6,000 NA 7,170
K650-WP † 5,200 14,000 80 x 175 40°F 490,000 6,500,000 6,500 NA 7,670
RV350-WP 2,800 6,600 60 x 110 40°F 217,000 3,500,000 3,500 25.0 7,375
RV400-WP 3,200 7,500 63 x 120 40°F 250,000 4,000,000 4,000 28.6 8,100
RV450-WP 3,600 8,400 70 x 120 40°F 275,000 4,500,000 4,500 32.1 8,320
RV500-WP † 4,000 9,750 75 x 130 40°F 320,000 5,000,000 5,000 35.7 9,080
RV550-WP † 4,400 12,000 75 x 160 40°F 400,000 5,500,000 5,500 39.3 9,820
RV600-WP † 4,800 13,600 80 x 165 40°F 490,000 6,000,000 6,000 42.9 10,530
RV700-WP † 5,600 14,800 80 x 185 40°F 575,000 7,000,000 7,000 50.0 11,960
RV800-WP † 6,400 15,000 100 x 150 40°F 600,000 8,000,000 8,000 57.1 13,450
Pool Heater Sizing Input Firing Rates
F SERIES
(Atmospheric)
DR SERIES
(Forced Draft)
CLM
SERIES
(Atmospheric
or Forced
Draft)
K SERIES
(Atmospheric)
Bryan Steam LLC — Leaders Since 1916
783 N. Chili Ave., Peru, Indiana 46970 U.S.A.
Phone: 765-473-6651 • Internet: www.bryanboilers.com
Fax: 765-473-3074 • E-mail: [email protected]
Approximate
Shipping
Weights (lbs)
Heater
Output
MBH
RV SERIES
(Forced Draft)
Heater
Series
Model
Number
Surface Area
Method
Pool
Surface
Area Sq. Ft.
Pool
Size
W x L ft.
Water
vs
Air Temp.
Pool
Gallonage
(Approx.)
Time Rise
Method
BTU's
Ft 3 Nat
Gas
Gallons
Oil
Per Hour
Indirect heat exchanger, combina-
tion thermometer and pressure gauge,
ASME-rated boiler relief valve, water
temperature control (240°F max. std.),
high limit control, probe LWCO, pool
water temperature controller, expansion
tank, fill and stop valve.
Atmospheric equipment
Electronic combustion safety control,
automatic operating gas valve, safety
gas valve, pilot solenoid valve, electric
ignition assembly, main manual gas
shut-off valve, pilot shut-off valve, pilot
and main gas pressure regulators, draft
controller, all controls installed and wired
standard voltage 120/1/60.
When ordering, please specify:
1. Boiler size
2. Supply and return
temperatures required
3. Boiler relief valve setting
4. Type of fuel: natural, LP,
or other gas and/or No. 2 oil
5. If gas, type, BTU content,
specific gravity and pressure
available
6. Electric power voltage,
phase and frequency
7. Optional extra equipment
or construction
8. Special approvals required
(UL, CSD-1, FM, or IRI)
9. Altitude
OPTIONAL EQUIPMENT:
1. Manual reset high limit control
2. Manual reset low water cutoff
3. Auxiliary low water cutoff
4. Combination low water cutoff
and feeder
5. Alarm bells or horns
6. CSD-1, FM, IRI or other insurance
approved control systems
7. Indicating lights, as desired
8. Lead-lag systems for two or more
boilers with or without outdoor
reset control
9. Draft control system
STANDARD EQUIPMENT :
Bryan Indirect Pool Heaters Standard and Optional Equipment
Forced Draft Equipment
Straight oil fired unit Electronic com-
bustion safety control, oil valve, oil igni-
tion transformer, two-stage fuel unit,
direct spark ignition, oil nozzle assembly,
control panel, all controls installed and
wired.
Combination gas-oil unit Electronic
combustion safety control, automatic
operating gas valve, safety gas valve,
pilot solenoid valve, pilot ignition
assembly, main manual gas shut-off
valve, pilot cock, pilot and main gas
pressure regulators, air safety switch,
manual fuel selector switch, oil valve,
gas pilot for both fuels, two-stage fuel
unit, oil nozzle assembly, control panel,
all controls installed and wired.
Straight gas fired unit Electronic com-
bustion safety control, automatic oper-
ating gas valve, safety gas valve, pilot
solenoid valve, pilot ignition assembly,
main manual gas shut-off valve, pilot
cock, pilot and main gas pressure regu-
lators, air safety switch, control panel,
all controls installed and wired.