BenQ FP781 - Manual (Page 16)

Benq LCD Color Monitor User's Guide
English 45
Troubleshooting
Frequently Asked Questions (FAQ)
✓ The image is blurred:
☞ Read the chapter, Installation/Adjustment and then select the correct resolution, refresh
rate and make adjustments based on these instructions.
☞
Do you use a VGA extension cable?
Remove the extension cable for the test. Is the image now in focus? If not, optimize the
image working on the description in the chapter, Installation/Adjustment. It is normal
for blurring to occur due to conduction losses in extension cables. You can minimize
these losses by using an extension cable with better conduction quality or with a built-in
booster.
☞
Does the blurring only occur at resolutions lower than the native (maximum) resolution?
Read the chapter Installation/Adjustment. Select the native resolution.
✓ Pixel errors can be seen:
☞
One of several pixels are permanently black, one or more pixels are permanently white,
one or more pixels are permanently red, green, blue or another colour.
Read the chapter Pixel error rates.
✓ The image has a faulty colour appearance:
☞ It has a yellow, blue or pink appearance.
On the monitor press the "Enter" key and use "<" or ">" key to select "RECALL" item and
press "Enter" key. Press "<" or ">" key to select "YES" and press "Enter" to recall fac-
tory settings. If the image is still not cor rect and the OSD also has a fault colour
appearance, then one of the three primary colours is missing in the signal input. Now
check the VGA cable contacts. If any pins are bent or broken off, then contact your
dealer or read the chapter, Additional Help, Repairs & Service.
✓ No image can be seen:
☞
Is the prompt on the display illuminated in green?
If the LED is illuminated in green, then press the "Enter" button on the monitor to access
the On Screen Display. If the message "Not supported Mode" appears there, read the
chapter Installation/Adjustment.