Bunn CRT5 - Manual (Page 5)

Page 5
EARLY MODELS W/OUT FAUCET
PLUMBING REQUIREMENTS (cont.)
EARLY MODELS W/FAUCET &
EXTERNAL FLOW CONTROL
1 Remove shipping cap(s) from the bulkhead fitting(s) on the rear of the brewer.
2. Attach the female flare fitting on the tube from the needle valve to the upper fitting on the rear of the brewer
and the female flare fitting on the manifold to the lower fitting on the rear of the brewer.
3 Flush the water supply line and securely attach it to the male flare fitting on the manifold.
4. Turn on the water supply.
5. Place an empty vessel beneath the faucet and lift the handle until water is dispensed.
10478.1 051412
feet from the 1 ⁄
2
" water supply line. A tight coil of copper tubing in the water line will facilitate moving the brewer
to clean the countertop. Bunn-O-Matic does not recommend the use of a saddle valve to install the brewer. The
size and shape of the hole made in the supply line by this type of device may restrict water flow.
LATE MODELS W/OUT FAUCET
LATE MODELS W/FAUCET
As directed in the International Plumbing Code of the International Code Council and the Food Code Manual
of the Food and Drug Administration (FDA), this equipment must be installed with adequate backflow pre-
vention to comply with federal, state and local codes. For models installed outside the U.S.A., you must
comply with the applicable Plumbing /Sanitation Code for your area.