Bissell LITTLE GREEN 1400 series - Manual (Page 7)

G
etting Ready
7
w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
1. To Fill the Clean/Solution Tank.
A. Remove the tank by lifting it straight up and
then away from the unit.
B. Unscrew the black cap at the bottom of the
Clean/Solution Tank.
C. Add BISSELL Little Green Formula to the FORMULA
fill line (8 oz.) on the Clean/Solution Tank.
Fill the Clean/Solution Tank with hot (NOT boiling)
tap water to the WATER fill line.
Replace and tighten the black cap.
D. Replace the Clean/Solution Tank by lining up the
vertical guides on the left side of the unit with
the indentations on the Clean/Solution Tank and
gently sliding it down into position.
2. Unwrap Vacuum Flex Hose completely from
Onboard Hose Storage.
3. Attach your selected cleaning tool to the Spray
Trigger Unit by pressing tool onto Spray Trigger
firmly until the button lock snaps into hole. Make
certain the tool is securely attached.
4. Twist the Quick Release Cord Wrap clockwise to unwrap
the Power Cord completely from Onboard Cord Storage
and plug into 120 Volt, 60 Hz grounded outlet as
described in Important Safety Instructions, page 3.
5. Press Power Switch to ON Position.
NOTE: If your unit has a built-in heater (not
standard on all models), first turn the black
power switch to “ON,” then the red heater
switch to “ON”. Within 30 seconds, the Heat
Indicator light will illuminate , indicating the
heater has reached the proper temperature.
Begin by pressing the Spray Trigger for 5-10
seconds to allow the non-heated water to travel
through the heater. Now the heated water and
cleaning solution mixture are ready to clean
carpet or upholstery. See below for detailed
cleaning instructions.
6. Press and hold Spray Trigger—spray will start in a
few seconds. Raise the tool slightly to check for spray.
Cleaning effectiveness will be enhanced if you
pre-treat heavily stained or highly-soiled areas.
Here’s how to do it:
1. Hold the Cleaning Tool just above the surface of
the carpet or upholstery to be cleaned. Press the
trigger to release a spray of cleaning solution
directly onto the soiled area.
2. Wait 3-5 minutes before cleaning.
P
re-Treating
WARNING:
Be sure to unplug the
cord before attaching
the TurboBrush.
1A
2
3 4
Power Switch
Heat
Indicator
Light
Heater Switch
5 6
1B
1C 1D
ug603-2302_1400_206.indd 7 ug603-2302_1400_206.indd 7 3/6/06 11:40:11 AM 3/6/06 11:40:11 AM