beautypg.com

Corded use, Overheat protection, Overload protection – Philips SatinPerfect Epilierer User Manual

Page 11: Using the precision epilator, Inserting the batteries

background image

3

Put the trimming comb on the shave, trim and style attachment (Fig. 17).

4

Follow steps 3 to 6 in section ‘Shaving the underarms and bikini line’.

Note: Make sure the surface of the trimming comb always stays fully in contact with the skin to ensure

an even trimming result.

5

When you have finished trimming, switch off the appliance and clean the shave, trim and style

attachment and the trimming comb (see chapter ‘Cleaning and maintenance’).

6

Leave the trimming comb on the shave, trim and style attachment when you store the

appliance.
corded use

To run the epilator from the mains, switch off the appliance and connect it to the mains.

overheat protection

The epilator has an integrated overheat protection, which prevents overheating of the appliance.
Note: To avoid overheating of the epilator, do not press the appliance too hard onto your skin. The epilator

works best when you move it over your skin without exerting any pressure.

1

If the overheat protection is activated, the appliance switches off automatically, the speed

setting indications and the charging light flash red.

2

Let the appliance cool down.

, The lights stop flashing after 30 seconds.

3

When the appliance has cooled down, you can switch it on again. If the lights start to flash

red again, the appliance has not yet cooled down completely.
overload protection

If you press the epilating head too hard onto your skin or when the rotating discs of the epilating

head get blocked (e.g. by clothes etc.), the appliance stops and the speed setting indications start to

flash red for 5 seconds.

1

Check if the rotating discs of the epilating head are blocked by turning the discs with your

thumb until you can remove whatever is blocking the rotating discs.

2

Switch on the appliance again.

Do not press the appliance too hard onto the skin.

using the precision epilator

inserting the batteries

1

Remove the lid of the battery compartment by sliding it down until it comes off the

appliance (Fig. 18).

2

Insert two AA 1.5V alkaline batteries into the battery compartment (Fig. 19).

Note: Make sure the + and - poles of the batteries point in the direction indicated in the battery

compartment.
Note: New batteries offer an operating time of up to 40 minutes.

3

Slide the lid of the battery compartment back onto the appliance.

Do not let metal objects come into contact with the battery terminals and do not short-circuit

the batteries.

EnglisH

11