Blaupunkt BROOKLYN MP35 - Manual (Page 33)

65
DANSK
ENGLISH
DEUTSCH
FRANÇAIS
IT
ALIANO
NEDERLANDS
SVENSKA
ESP
AÑOL
PORTUGUÊS
Entering the power-on
message
After you switch on your device, the
system displays a short message in the
display. The factory default setting is the
“BLAUPUNKT” text. Instead of this, you
can enter your own text up to 9 charac-
ters long.
➮
Press the MENU button 7.
➮
Press the or button 6 repeat-
edly until “ON MSG” appears in the
display.
➮
Press the button
6.
The default text for the power-on mes-
sage appears in the display. The input
cursor flashes at the beginning of the
line.
Note:
● You can delete the entire line by
pressing and holding down the
or button
6 for longer than
two seconds.
To enter a different text,
➮
select a letter using the or but-
ton
6.
➮
Move the selection cursor using
the or button
6.
Once you have entered the message,
➮
press the MENU button
7 twice.
The settings are saved.
Configuring the level
display
The level display temporarily provides
you with a symbolic representation of
the volume and audio settings whilst you
are adjusting them.
When you are not changing any set-
tings, the level display depicts the peak
music/speech output. You can switch
the level display on/off.
➮
Press the MENU button 7.
“MENU” appears in the display.
➮
Press the or button
6 repeat-
edly until “PEAK LVL” appears in
the display.
➮
Press the or button 6 to
switch between “PEAK ON” and
“PEAK OFF”.
When you have finished adjusting the
setting,
➮
press the MENU button
7 twice.
POWER-ON MESSAGE LEVEL DISPLAY
02BrooklynMP35_gb 19.08.2005, 14:45 Uhr 65