beautypg.com

How to use the machine – auto mode – Braun Tassimo User Manual

Page 5

background image

How to use the machine – Auto Mode

6

How to use your machine – Auto Mode

How to use your machine – Auto Mode

7

Rinse and fill the water container with fresh cold water. Turn on

the machine by pressing the on/off switch. Open the brew

mechanism. Opening the brew mechanism will initiate the

heating of the water and the HEATING light will flash.

Place a clean cup on the cup stand, adjusting the height of the

stand up or down so that the rim of the cup is close to the

brew mechanism.

Position your choice of T-DISC on the T-DISC holder, label facing

down. Firmly close the brew mechanism by pressing the clamp

down until it shuts. The HEATING light may flash again as the

machine heats the water to the required temperature for

your drink.

When the AUTO light illuminates, press and release the start/

stop button. Brewing will start automatically. There may be

a short pause during brewing; this is normal. The AUTO light

flashes throughout the brew cycle. When the machine has

finished brewing, the indicator light will move from AUTO to

MANUAL and then, after a delay of 30 seconds, to HEATING.

• When the indicator light moves to MANUAL, you can customise

your cup as described in “Manual Mode” (See page 8).

• At any time during the “Auto Mode”, you can stop the brew cycle

by pressing and releasing the start/stop button. The machine

will stop and any remaining liquid inside the T-DISC will empty

into the cup.

Open the brew mechanism, remove the T-DISC and discard.

Your drink is now ready to be enjoyed.

You can prepare the next beverage right away by repeating

steps 2 – 5.

• Always remove the used T-DISC from the machine right after

brewing. When removing the T-DISC, handle it by the thumb

tab to avoid contact with heated areas.

• Please ensure that there is enough water in the water

container. If the water level is too low, all the indicator lights

will flash, signalling that the water container needs to

be refilled.

• To adjust the cup stand, insert your finger in the centre

of the stand, lift and turn.

• To avoid spilling over, please choose the right sized cup for

the drink you are making. See page 3 “Tips for the Perfect Cup”.