Bayou Classic 700-701 - Manual (Page 20)

O
FF
- CLOCKW
IS
E
O
FF
- C LO CK
W
IS
E
18
HOW TO REIGNITE BURNER ON FRYER
Turn COUNTER-CLOCKWISE
to Disconnect Turn OFF
LP Cylinder.
Close Fully
1
Turn OFF Regulator.
Close Valve Fully
2
Disconnect
Regulator
3
1. If burner flame does NOT ignite immediately, or is accidentally extinguished, turn the valve on
LP Gas Cylinder clockwise to OFF. Then turn regulator valve clockwise to OFF position.
Wait 5 minutes for gas to evacuate before re-lighting. Always use caution when re-lighting as appliance
frame and oil will be hot.
2. Follow steps 1-5 on previous page, to reignite burner.
Use caution when re-lighting the burner, as hot oil from
fryer may have splattered and run down the sides of
the unit creating a slick surface. Use caution not to bump
the appliance when re-lighting the burner.
3. If the burner does not light within the first few attempts, there is a problem with the gas supply.
Turn off the gas at the cylinder and regulator. DO NOT attempt to operate fryer until the problem is
found and corrected. Refer to Troubleshooting on pages 23 - 24.
TURNING OFF THE FRYER
NOTE: Turn off LP gas cylinder valve first to prevent gas from being left in the regulator hose system
under pressure.
When finished using the appliance, turn off gas from cylinder valve first. It will take a few seconds for
the fire to go out and for the propane gas to "bleed" from the hose and regulator assembly. After the
fire is completely out, turn regulator valve to the "OFF" position.
1. Turn OFF the LP gas cylinder valve clockwise until it stops.
2. Turn regulator valve to the OFF position, clockwise until it stops.
3. To disconnect Regulator Hose Assembly, turn the large coupling nut counter-clockwise by hand.
Light BURNER HERE
WARNING
The LP gas cylinder valve should always be in the OFF or closed position when the cooker is not
in use.